Xerox Phaser 750DP 서비스 매뉴얼 - 페이지 34
{카테고리_이름} Xerox Phaser 750DP에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 750DP 40 페이지. Digital color printer / copier
Xerox Phaser 750DP에 대해서도 마찬가지입니다: 사양 (2 페이지), 브로셔 및 사양 (4 페이지), 참조 매뉴얼 (8 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
Status
Code
10-373
The control logic sensed that the Pressure Roll could not maintain temperature during a copy run.
Initial action:
Ensure that the Pressure Roll surface is clean (no debris, paper, etc.) (REP 5.35)
Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where
the Thermistor contacts the Pressure Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-374
The control logic sensed that the Pressure Roll did not reach operating temperature within 150 seconds after Power
Saver mode was exited.
Initial action:
Ensure that the Pressure Roll surface is clean (no debris, paper, etc.) (REP 5.35)
Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where
the Thermistor contacts the Pressure Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-375, 376
The control logic sensed that the Pressure Roll temperature exceeded 180˚.
Initial action:
Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where
the Thermistor contacts the Pressure Roll (REP 5.37).
If the problem still exists:
Place a service call.
Fault Code Procedures
Description/Direction
5/98
2-34
5750 DocuCare Service Manual