Xerox Phaser 750DX 서비스 매뉴얼 - 페이지 29
{카테고리_이름} Xerox Phaser 750DX에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 750DX 40 페이지. Digital color printer / copier
Xerox Phaser 750DX에 대해서도 마찬가지입니다: 사양 (2 페이지), 브로셔 및 사양 (4 페이지), 참조 매뉴얼 (8 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
Status
Code
10-105, 106
The control logic sensed a timing error from the Fuser Exit Sensor.
Initial action:
Check for deformation of the Exit Chute (Lower/Upper).
Check for paper path obstructions.
Check for contamination, damage or wear on the Heat Roll (REP 5.31) and Pressure Roll (REP 5.35) sur-
face.
Check the Stripper Finger for defects and obvious damage (REP 5.38).
If the problem still exists:
Place a service call.
10-358
The control logic sensed an error from the Thermistor failure detection circuit.
Initial action:
Check the Heat Roll Control and Overheat Thermistors for cleanliness, damage and excessive wear at the
point where the Thermistor contacts the Heat Roll (REP 5.37).
Check the Pressure Roll Control and Overheat Thermistors for cleanliness, damage and excessive wear at
the point where the Thermistor contacts the Pressure Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-359
The control logic sensed an open circuit from the Heat Roll Control Thermistor.
Initial action:
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
5750 DocuCare Service Manual
Description/Direction
5/98
2-29
Fault Code Procedures