Xerox Versant 280 Press 매뉴얼 - 페이지 10
{카테고리_이름} Xerox Versant 280 Press에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Versant 280 Press 44 페이지. Customized envelope feeder
Xerox Versant 280 Press에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지)
페이지 인쇄
A
Versant Error Messages
Does the Versant User Interface display a fault showing "The original size could
not be detected..."?
N
Y
Adjust the Versant Paper Tray Guides to meet or "hug" the Envelope Feeder Side Guides.
Does the Versant User Interface display a fault showing "Paper Size/Orientation
in Tray 5 is Different..."?
N
Y
Adjust the length value and width value on the Versant Paper Tray Attributes screen (on
the Versant User Interface) to match the actual media loaded in the Hopper.
NOTE: If the envelope size is measured in hundredths-of-an-inch (for example, 4.75), you may
be required to try a slightly larger size (4.8) on the Versant User Interface (since the Versant
User Interface only accepts sizes measured in tenths-of-an-inch).
Does the Versant User Interface display a fault showing "Tray 5 is Out of Paper..."?
N
Y
Are some envelopes (more than one) feeding and printing before the message appears?
N
Y
Clean the Feeder Belts (REP 4.1).
The feeder may not be properly registered against the OHCF or Side MSI Tray.
Remove the Feeder from the OHCF or Side MSI Tray.
For OHCF configurations, reinstall the Feeder and verify the OHCF back guides are adjacent to
the Feeder.
For Side MSI Tray configurations, reinstall the Feeder and verify the Side Guide Blocks are
adjacent to the Feeder.
OHCF Configuration
Call CAS at 585-427-5414 for assistance.
2-4
MSI Tray Configuration
Xerox Customized Envelope Feeder – Problem Solving Guide