Xerox Versant 280 Press 매뉴얼 - 페이지 6
{카테고리_이름} Xerox Versant 280 Press에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Versant 280 Press 44 페이지. Customized envelope feeder
Xerox Versant 280 Press에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지)
페이지 인쇄
Overview, continued.
Feature
Hopper Side Guides
Wedge
Stand (not shown)
Feed Belts (not shown)
Discharge Belt (not shown)
Hold Down
Separator
Jog Button
Ready/Suspend Switch
Reset Button
Stand Mount Interface
Locator Blocks
1-2
Description
The stack of product to be fed is loaded between the Hopper Side Guides to
help keep it aligned for entry through the separator assembly area.
The wedge provides the support necessary to transfer the center of gravity
of the product stack in the hopper up off the deck plate onto the feed belts
and against the separator assembly.
The stand supports the Feeder including casters to provide easy mobility.
The feed belts provide the friction and motion necessary to pull individual
product from the bottom of the stack and through the separator assembly
area. The feed belts must be cleaned with isopropyl alcohol to ensure
proper functionality.
The long discharge belt provides the friction and increased speed necessary
to pull the piece of product away from the separator assembly, resulting in
a gap between each piece of product as it leaves the separator assembly
area. The discharge belts must be cleaned with isopropyl alcohol to ensure
proper functionality.
The Hold Down assembly forces the product onto the discharge belt so it
can be singled out after it exits the separator assembly. The Hold Down
Rollers must be in contact with the clear discharge belt but not so low that
the black bar is resting on the belt. This would result in jams.
The separator assembly is adjustable so the gap between the separator
assembly and the feed belts allows only a single piece of product at a time
to pass under the separator. Allows quick adjustment from paper thickness
to envelope thickness.
Advances the Feeder at a fixed speed. This function is useful during Feeder
setup and may be used to clear jams.
Toggles between ready mode and suspend mode.
Resets the Feeder from a fault condition. The Reset Button is only present
on Feeders with "XPF125Axxx" and "XPF125Bxxx" serial numbers.
Designed to easily fit over the top of the stand. Once installed onto the
stand, fasten with provided thumb screws.
Designed to help align the Feeder within the Versant Paper Tray while
positioning the Feeder during installation, or when clearing a jam.
Xerox Customized Envelope Feeder – Problem Solving Guide