Xerox 6100BD - Phaser Color Laser Printer 보안 매뉴얼 - 페이지 31

{카테고리_이름} Xerox 6100BD - Phaser Color Laser Printer에 대한 보안 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 6100BD - Phaser Color Laser Printer 38 페이지. Disk overwrite installation and usage
Xerox 6100BD - Phaser Color Laser Printer에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 사양 (2 페이지), 사용자 설명서 (32 페이지), 브로셔 및 사양 (4 페이지), 사용자 설명서 (28 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 릴리스 노트 (2 페이지), 시작하기 매뉴얼 (37 페이지), 매뉴얼 (34 페이지), 매뉴얼 (34 페이지), 시작하기 매뉴얼 (34 페이지), 사용자 설명서 (32 페이지), 매뉴얼 (11 페이지), 설치 및 운영 매뉴얼 (8 페이지)

Xerox 6100BD - Phaser Color Laser Printer 보안 매뉴얼

Digital Certificates

Network Protocol

Network
Protocol
Samba (SMB)
XSun
Security Guide
SSL/TLS cannot be enabled unless a digital certificate has been
installed on the system, using the Add Certificate button. Installing
a digital certificate can only be done by someone with
administrator privileges.
The administrator selects SSL/TLS from the [Setup] Menu and
clicks on the [Add Certificate] button. This invokes the Add
Certificate wizard. There are two options regarding digital
certificates. One option is "Self-signed certificate". This is selected
when no third party Certificate Authority is being used.
Another option is "Signed Certificate from a Certificate Authority".
In this case, the administrator needs to supply the fully qualified
domain name, IP address, organization and country of the
Certificate Authority.
If the choice is to use a Certificate Authority, all Certificate
information needs to be held in a file and sent to the Certificate
Authority. The Authority returns a valid certificate that must be
installed on the system.
NOTE: A self-signed certificate is not as secure as a certificate
signed by a Certificate Authority. A self-signed certificate is the
most convenient way to begin using SSL/TLS and does not
require the use of a server functioning as a Certificate Authority or
a third party Certificate Authority.
Once the Digital Certificate has been installed, the Enable SSL/
TLS selection becomes available among the [Setup] options. At
that time the administrator can select the mode of operation,
Normal or Secure, from a drop-down menu.
This section addresses Network Protocol, name service changes
and the changes that occur when security is invoked.
The table below addresses the list of Network Protocols that are
used by the Xerox FreeFlow Print Server software or Xerox client
operations.
Table 2-7
Network Protocols
Network sharing protocol required for Hot Folders and SMB
filing (Nuvera only).
Required for functionality of Xerox FreeFlow Print Server
diagnostics software.
Required
27