Xerox 7700 설치 매뉴얼 - 페이지 9

{카테고리_이름} Xerox 7700에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 7700 42 페이지. Color laser printer
Xerox 7700에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 보충 설명서 (1 페이지), 설정 및 빠른 참조 매뉴얼 (40 페이지), 설치 매뉴얼 (33 페이지), 서비스 매뉴얼 (29 페이지), 서비스 매뉴얼 (17 페이지), 설정 매뉴얼 (2 페이지)

Connecting Your Printer to a Network

Ethernet Interface

Conforms to IEEE 802.3 and Ethernet II standards.

Twisted pair (10BaseT or 100BaseTx) connection.

Thick coax (10Base5) and thin coax (10Base2) connections require adapters; contact

your dealer to obtain adapters, cables, and terminators.

Caution

To avoid damaging the Ethernet interface, turn off the printer before making any

Ethernet connections.

Ethernet Connections and Indicators

RCV (receive) indicator (green); blinks while the interface is receiving.

XMT (transmit) indicator (yellow); blinks while the interface is transmitting.

Twisted pair (10BaseT) connector.

Ethernet Cables

The 100BaseTx Ethernet requires Category 5 (100-Ohm UTP) cabling.

To fully comply with EMI (electromagnetic interference) specifications, the use of

shielded or screened cables may be required. "Shielded" describes IBM-defined cables

used with the DB-9 connector. "Screened" describes cables that are electrically similar to

Category 4 UTP (Unshielded Twisted Pair), but with an added shield or screen.

Caution

Do not use "silver satin" telephone extension cables for 10BaseT networks, either

as drop cords or as patch cables in the wiring closet. (Silver satin cables are flat,

usually silver or gray, with 28-gauge stranded or tinsel conductors.) Do not use

shielded twisted pair cable intended for IBM Token Ring networks or voice-grade

(level 1 or 2) unshielded twisted pair cables. These cables do not meet the

requirements for 10BaseT and will lead to unreliable operation.

7700-02

Phaser 7700 Color Printer