Xerox DocuColor 250 릴리스 노트 - 페이지 5

{카테고리_이름} Xerox DocuColor 250에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 250 34 페이지. Printer-copier
Xerox DocuColor 250에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (47 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 사용 (2 페이지), 설정 매뉴얼 (6 페이지), 복사용 소책자 생성 (2 페이지), 시스템 설정 목록 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 평가자 매뉴얼 (20 페이지), 평가자 매뉴얼 (18 페이지)

Page 5

SNMP limitations

If you change the community name or disable SNMP, WebSetup does not work. Power the

device off, then on when you make a change to the SNMP tab in More Setup.

If you disable SNMP, the automatic search for the Fiery feature in Command WorkStation,

which is based on SNMP, does not work.

If you disable SNMP, the following features are affected:

• Two-Way communication

• All Fiery applications that search for Fiery controllers using SNMP (Command

WorkStation, Remote Scan, and Downloader)

• Xerox CentreWare

• Xerox MIBs

After you change and save the community name, a Login window appears. To validate the

changes, enter "Admin" as the User Name and the Administrator password in Command

WorkStation as the Password.

Network

Ethernet speed

The Ethernet speed setting under Network Setup on the copier Control Panel lists two

choices that are not supported: 10BASE-TX (Full Duplex) and 100BASE-TX (Full Duplex).

It does not list a choice for a 1-Gbit speed. Use WebSetup if you want to set the speed

to 1 Gbit.

Novell network

If the Fiery is connected to the Novell server through a switch and you experience connection

problems, it might be because of the default port conﬁguration of the switch. For example,

if you have a Cisco 2950 switch, you must conﬁgure the port connected to the Fiery and the

port connected to the Novell server as follows, to allow unimpeded trafﬁc between the two.

interface FastEthernet0/2

switchport mode access

no ip address

spanning-tree portfast

interface FastEthernet0/6

switchport mode access

no ip address

spanning-tree portfast

Part Number: 45045321