Xerox DocuColor 45054549 사용자 부록 - 페이지 16

{카테고리_이름} Xerox DocuColor 45054549에 대한 사용자 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 45054549 30 페이지. For docucolor 240/250

Manual duplex

printing

Manual duplex printing using Tray 5 (Bypass) or Tray 6 (Oversized)

Manual duplex printing is supported using either Tray 5 (Bypass) or Tray 6 (Oversized) as the

paper source. You can print duplex output in a fully manual mode, determining the required

paper manipulation yourself, or you can print in a semi-manual mode, in which the

Fiery EXP250 prompts you to perform the manual steps required.

O PRINT IN A FULLY MANUAL MODE

1 Print two jobs: the ﬁrst containing the even-numbered (Side 2) pages, and the second

containing the odd-numbered (Side 1) pages.

Since the jobs are separate, you can even print from different applications if desired. Or you

can print from one document, but print even-numbered pages as one job and odd-numbered

pages as one job.

2 For the ﬁrst job, set the print options as follows:

• Face-Down Printing = Face Up

• Paper Source = Tray 5 (Bypass) or Tray 6 (Oversized)

• Page Size and Media Type = type of media loaded in the Paper Source

3 Print the ﬁrst job.

4 Notice how the pages are oriented in the output tray before removing them.

5 Turn the pages over so that the printed side faces down and load them back in the same tray

used to print the ﬁrst job.

Depending on how you ﬂip the pages, you can print Side 1 with the same orientation as

Side 2 (Top-Top) or rotated 180 degrees relative to Side 2 (Top-Bottom). The illustration

below shows the output for Top-Top and Top-Bottom for both Portrait and Landscape jobs.

Portrait

Landscape

For Top-Top printing, keep the pages oriented the same way as they were in the output tray,

except face down. For example, if the pages are upside down and face up, load them upside

down and face down.

Top-Top

Page

Top-Bottom