Xerox Document Services Platform Series 시작하기 매뉴얼 - 페이지 20

{카테고리_이름} Xerox Document Services Platform Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Document Services Platform Series 27 페이지. Document services platform series

페이지 인쇄

DOCUSP 3.x

W-6 data element definitions

This section defines the data elements determined by the

network administrator or the Xerox Systems Analyst during the

setup of the NetWare Gateway on each Novell Server that will

be transferring documents from Novell clients to the controller.

To support a smoother, faster install process, make sure these

data elements are known and entered in this worksheet before

the scheduled day of installation.

Novell Internal network number: This is the internal network

number, assigned to the controller, that identifies the DocuSP

controller on the Novell network. This data element must be a

new, eight digit hexadecimal number, that is a unique number on

the Novell network, and is available from the network

administrator.

NOTE: If necessary, pad the number with zeros from the left to

achieve the eight digits.

Novell network number: This is an eight digit, hexadecimal

network number that identifies the Novell network. The external

network number can be any number defined that falls within the

range of 1 to FFFFFFFFE.

NOTE: This number must be the same on both the Novell server

and the controller.

You can find the Novell network number by entering the

CONFIG command at the Novell File Server system console

prompt, as in the following Frame type ETHERNET_802.3

example. The network number is in bold, on the last line of this

example, as the LAN protocol IPX network number, and may

also be referred to as the Ethernet Net Number.

File server name: Cust 2

IPX internal network number: 0123A.B09

Novell NE2000

Version 3.25 June 17, 1993

Hardware setting: I/O Port 300h to 31Fh,

Interrupt 3h

Node address 00009B99E999

Frame type: ETHERNET 802.3

Boardname: PUBLIC

LAN protocol: IPX network 0000BB09

At this point make a note of the name of the file server since it

will be needed later. This information will appear after the entry,

File server name:. The comparable ETHERNET_Il entry would

look like the follow example. In the following example the name

of the file server is Cust_2 and the network number is in bold, on

the last line as the LAN protocol IPX network number.

Remember, this is an example, and your setup will most likely be

different.

File server name: Cust 2

IPX internal network number: 0123AB09

XEROX DOCUMENT SERVICES PLATFORM SERIES

GETTING READY FOR THE DOCUSP INSTALLATION