Xerox DocuSP 4.2 Differences 매뉴얼 - 페이지 8

{카테고리_이름} Xerox DocuSP 4.2 Differences에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuSP 4.2 Differences 34 페이지. Docusp getting started
Xerox DocuSP 4.2 Differences에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (34 페이지)

페이지 인쇄

Imposition/Layout enhancements

DocuSP 4.2 provides the user with a new template, the

Z-sort template. In addition, the Z-sort, or ZIP-sort

capability has been extended to all multiple-up options.

This addition allows multiple-up (e.g. 4-up, 6-up, 9-up,

etc.) to be cut and then stacked in a predefined order

so that postal sort order is maintained. See the figure

below.

Detail shot of new Cut and Stack control in the Layout FAB

The output may be either single-sided or double-sided,

and the layout numbers, as is suggested by the layout

example shown above, the pages and images

appropriately so that the order is maintained when cut

and stacked.

As a specific example of N-up imposition, consider the

2-Up case. 2-Up Flip right can be programmed by

selecting "Repeated" and by checking the "Flip Right"

box. In a similar fashion, the legacy 2-Up Cut and

Stack option can be programmed by selecting "Cut and

Stack" and checking the "Cut On Binding Edge" box.

DocuSP 3.8 and 4.0 to 4.1 Differences Document