Xerox Phaser 7300DN 사용자 설명서 - 페이지 39

{카테고리_이름} Xerox Phaser 7300DN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 7300DN 50 페이지. Quick reference guide
Xerox Phaser 7300DN에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (40 페이지), 특징 (1 페이지), 브로셔 및 사양 (4 페이지), 기능 설명서 (40 페이지), 지원 매뉴얼 (28 페이지), 종이 매뉴얼 (34 페이지), 설정 매뉴얼 (18 페이지), 설정 및 빠른 참조 매뉴얼 (45 페이지)

Macintosh troubleshooting (MacOS 8.x/9.x/10.1)

The steps in this procedure should eliminate cabling, communication, and connection problems.

Complete these steps, then run a test print from your software application. If the job prints, no further

system troubleshooting is necessary. For print quality problems, refer to the Troubleshooting section of

the Interactive Documentation CD-ROM.

Perform Steps 1 and 2 if you are using MACOS 8.x or 9.x.

Start the Chooser in Operating System 8 or greater software and select the LaserWriter driver.

If the printer name appears, your printer is communicating through the network. You do not need

to perform any of the checks outlined in this section. If your printer name does not appear, proceed

to Step 3.

Verify that the printer is plugged in, turned on, and connected to an active network.

Verify cable connection to the printer from the network.

For AppleTalk, follow the steps below. For TCP/IP (MacOS X, version 10.1 only), continue to

Step 6.

From the printer's front panel, verify that EtherTalk is enabled. If not, enable it in the front

panel and reset the printer.

Print the Configuration Pages and verify that EtherTalk is enabled.

From the Configuration Pages, verify the Zone. If you have multiple zones on your network,

be certain your printer appears in the desired zone.

Perform Step 6 only if you are using MacOS X, version 10.1.

For TCP/IP, follow the steps below.

Open the Network Utility and select the Ping tab.

Enter your printer's IP address.

Click Ping. If you do NOT get a response, confirm that your TCP/IP settings are correct for

both your printer and Macintosh.

If you are still unable to print, refer to the Xerox web site at

support

or access PhaserSMART through CentreWare Internet Services. From a web browser,

enter your printer's IP address. Select Support. Select the Technical Support link to access

PhaserSMART.

Phaser® 7300 Color Printer

Macintosh EtherTalk Network (MacOS 8.x/9.x/X, version 10.1)