Xerox Phaser 7300DN 설정 매뉴얼 - 페이지 15

{카테고리_이름} Xerox Phaser 7300DN에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 7300DN 18 페이지. Quick reference guide
Xerox Phaser 7300DN에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (40 페이지), 특징 (1 페이지), 브로셔 및 사양 (4 페이지), 사용자 설명서 (50 페이지), 기능 설명서 (40 페이지), 지원 매뉴얼 (28 페이지), 종이 매뉴얼 (34 페이지), 설정 및 빠른 참조 매뉴얼 (45 페이지)

페이지 인쇄
Xerox Phaser 7300DN 설정 매뉴얼
Note:
If you use the installer from your printer's software CD-ROM, the IP Address is set automatically.
To manually set the printer's IP address:
1. At the printer's front panel, select
2. Scroll to the
Connection Setup Menu
3. Scroll to
TCP/IP Address Menu
4. Scroll to
DHCP/BootP
5. Scroll to
TCP/IP Address
6. Enter an IP address like the example above.
7. Scroll to
TCP/IP Network Mask
8. Enter a network (subnet) address. (If you use the IP address in the above example,
set a Subnet Mask of 255.255.255.0)
9. Scroll to
TCP/IP Gateway
10. Enter a Gateway (router) address. (If you use the IP address in the above example,
set a Gateway address of 192.168.1.1)
11. Scroll to
Exit
and press OK.
To set a static IP address on your computer:
Windows 95/98/Me
1. From the Start menu, right-click Network Neighborhood and select Properties.
2. On the Configuration tab, select the TCP/IP protocol for your network card, then select Properties.
3. On the IP Address tab, select Specify an IP address. Enter an IP address and Subnet Mask, and click OK.
(If you use the IP address noted above, set a Subnet Mask of 255.255.255.0).
4. Click OK and restart Windows.
Windows 2000/XP
1. From the Start menu, right-click My Network Places and select Properties.
2. Right-click Local Area Connection and select Properties.
3. If you do not have TCP/IP available, you should first click Add and select Protocol. Click Add and select
Internet Protocol TCP/IP.
4. On the General tab, select the TCP/IP protocol for your network card. Click Properties.
5. On the General tab, select Use the following IP address. Enter an IP address and Subnet Mask, and then click
OK. (If you use the IP address in the above example, set a Subnet Mask of 255.255.255.0).
6. Click OK and restart Windows, if prompted.
Windows NT 4.x
1. From the start menu, right-click Network Neighborhood and select Properties.
2. On the Protocols tab, select TCP/IP Protocol and click Properties.
3. On the IP Address tab, select Specify an IP Address. Enter an IP Address and Subnet Mask in the field and
click OK. (If you use the IP address noted above, set a Subnet Mask to 255.255.255.0.)
4. Click OK and restart Windows.
Page 2 of 3
Menus
and press OK.
and press OK.
and press OK.
and press OK until it displays OFF.
and press OK.
and press OK.
and press OK.