Xerox Phaser 7750 빠른 설정 - 페이지 3

{카테고리_이름} Xerox Phaser 7750에 대한 빠른 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 7750 5 페이지. Color laser printer
Xerox Phaser 7750에 대해서도 마찬가지입니다: 사양 (4 페이지), 사용자 설명서 (35 페이지), 브로셔 (8 페이지), 소유자 매뉴얼 (4 페이지), 사양 (2 페이지), 네트워크 매뉴얼 (8 페이지), 보충 설명서 (5 페이지), 매뉴얼 (5 페이지), 보충 설명서 (2 페이지), 보충 설명서 (16 페이지), 설치 매뉴얼 (6 페이지), 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (3 페이지), 유지 관리 매뉴얼 (1 페이지), 컬러 매뉴얼 (4 페이지), 설치 매뉴얼 (33 페이지), 빠른 참조 매뉴얼 (8 페이지), 서비스 매뉴얼 (14 페이지), 빠른 참조 매뉴얼 (8 페이지), 빠른 참조 매뉴얼 (8 페이지), 설정 매뉴얼 (2 페이지), 사용자 문서 (17 페이지), 설정 매뉴얼 (2 페이지), 메모리 추가 매뉴얼 (2 페이지)

Requirements

Verify that you:

■

Are operating a Windows-based system with CentreWare DP software installed and at

least one printer driver installed

■

Are a NetWare Network Administrator, an administrative person with ADMIN/

SUPERVISOR, or ADMIN/SUPERVISOR EQUIVALENT within login rights to the

NetWare Server(s) servicing the Phaser printer

■

Have a basic knowledge of NetWare

Novell NetWare Troubleshooting Quick Check

Verify that the printer is plugged in, turned on, and connected to an active network.

Verify that the printer is receiving network traffic by monitoring the LEDs on the back of

the printer. When the printer is connected to a functioning network and receiving traffic,

its link LED is green, and its amber traffic LED is flashing rapidly.

Verify that the client is logged into the network and printing to the correct print queue.

Verify that the user has access to the Phaser printer queue.

Verify that the Phaser printer NetWare print queue exists, is accepting jobs, and has a print

server attached. If it does not, use the Setup Wizard in CentreWare DP to reconfigure the

print queue.

Print the "Configuration Page". Verify that Printer Server is enabled. Set the frame type

to the frame type your NetWare server is using.

Note

To determine your NetWare IPX frame type, type config at the Novell console screen.

On networks using multiple IPX frame types, it is critical that the frame type be set

correctly.

Verify that the Primary Server is set (NetWare 3.1x only). The primary server should

have been set during initial queue setup and installed using CentreWare DP. If it is not set,

use CentreWare DP to set it, then reset the printer.

Note

Setting the Primary Server is extremely important on large networks.

Go to

www.xerox.com/office/support

problem.

if the above steps fail to resolve the printing

Phaser® 7750 Color Laser Printer

3-40

Novell NetWare