Xerox Synergix 8825 소프트웨어 설명서 - 페이지 23

{카테고리_이름} Xerox Synergix 8825에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Synergix 8825 30 페이지. Windows nt 4.0 postscript print driver user guide
Xerox Synergix 8825에 대해서도 마찬가지입니다: 운영자 매뉴얼 (48 페이지), 설정 매뉴얼 (20 페이지), 릴리스 노트 (23 페이지), 보충 설명서 (26 페이지)

페이지 인쇄

Document Properties Dialog (Job Tab Parameters)

FINISHING

Note: If you do not have a Finishing (.fin) File installed, "Folder bypass"

will be displayed in gray and any other options will be unavailable for

selection.

If you installed a Finishing (.fin) File from the "Select Finisher" option of

the Printer Properties dialog "Device Settings Tab," as stated in this User

Guide, the finishing drop-down list will be available for your selection.

You can use the drop-down list to select either Printer default or User

defined.

Printer Default uses the default finisher settings stored in the Controller,

previously set up using the Web Printer Manager Tool.

If you select User defined, the Settings... button will be enabled. When

you click this button, a Finishing Options dialog will display allowing you to

select the finishing program to use with your Finishing Device, override

features of the finishing program, select an output bin, and to let the

finisher know the location of the Title block in your document, if any. For

an explanation of the individual dialog features, click the "?" key in the

upper right corner of the dialog.

PLOT NESTING

This option allows you to determine if plot nesting will be applied to your

print job. The purpose of Plot Nesting is to efficiently group the printing of

plots on a single sheet of media to eliminate media waste. The factory

default setting is Off, however you can select either Printer default or

Single job as an option.

Printer Default uses the default plot nesting settings stored in the

Controller, previously set up using the Web Printer Manager Tool. These

pre-determined settings include: Exclusive nesting (i.e. reserved to a

Single Job), Timeout, Margins (between nested plots), and maximum

Nesting Length.

XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide

Single Job creates a plot nest restricted to the contents of your current

job. Plots from other job sources will not be intermixed with plots from

your job. If you select Single Job, the Settings... button will be enabled.

When you click this button, a Plot Nesting Options dialog will display

allowing you to adjust the margins between printed images on your

nested page.