Xerox Synergix 8830 설정 매뉴얼 - 페이지 7

{카테고리_이름} Xerox Synergix 8830에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Synergix 8830 20 페이지. Windows nt 4.0 postscript print driver user guide
Xerox Synergix 8830에 대해서도 마찬가지입니다: 운영자 매뉴얼 (48 페이지), 릴리스 노트 (23 페이지), 보충 설명서 (26 페이지), 소프트웨어 설명서 (30 페이지)

Xerox Synergix 8830 설정 매뉴얼
NONE. Your choices will show on the screen, for example: (plt00t). An example queue
name is "plt99" when NONE is selected.
- Press the Update Printer button to set your choices.
NOTE: See the Configure Remote Printer Status Messages at the end of this document.
Select CONFIGURATION > NETWORK > TCP/IP.
- Check that the Subnet Mask, IP Address, and Gateway settings are correct. These are
needed so that your workstation will be able to communicate with your FreeFlow Accxes
compliant scanner and printer.
- If the printer is not properly auto negotiating with the network, then set the
Speed/Duplex to something other than "Auto". The other selectable options are "10
Mbps - Half Duplex", "10 Mbps - Full Duplex", 100 Mbps - Half Duplex", and "100 Mbps -
Full Duplex". The Auto setting will properly auto negotiate with a YKE/YKE-N's 1000
Mbps switch.
- Select HELP to access further information from the Help files.
TCP/IP Address Parameters from the Printer
Control Panel

510, 8825, 8830, 8850 Printers:

Perform the following steps:
1. At the Printer Control Panel, when the display shows <IDLE>, press ONLINE
2. When the display shows <PAUSED>, press ENTER
3. When the display shows <UTILITIES>, press NEXT
4. When the display shows <SETUP I/O PORTS>, press ENTER.
5. When the display shows <SCSI>, press NEXT until the display shows <ETHERNET
TCP/IP>. Press ENTER.
Once you have access the ETHERNET TCP/IP menu, perform the following steps at the printer
control panel to enable DHCP or RARP/BOOTP:
6. Press the NEXT key until DHCP ENABLE=OFF or RARP/BOOTP ENABLE=OFF is
displayed.
7. Press the ENTER key followed by the NEXT key to change the setting to ON, then press
the ENTER key.
NOTE: Verify that you have DHCP enabled.
8. Press the EXIT key as many times as required to go back to PAUSED mode.
9. Press the ONLINE
10. Wait 60 seconds and cycle the printer power. The printer will reflect the new TCP/IP
address after booting up.
11. Printer a CONFIGURATION & SETTINGS TEST PRINT and save it for future reference.
FreeFlow Accxes Printer System and Web Print Management Tool Setup Guide
key to put the printer back on line. The display will show IDLE.
.
.
.
3