Xerox Synergix 8830 보충 설명서 - 페이지 9
{카테고리_이름} Xerox Synergix 8830에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Synergix 8830 26 페이지. Windows nt 4.0 postscript print driver user guide
Xerox Synergix 8830에 대해서도 마찬가지입니다: 운영자 매뉴얼 (48 페이지), 설정 매뉴얼 (20 페이지), 릴리스 노트 (23 페이지), 소프트웨어 설명서 (30 페이지)
페이지 인쇄
Input Orientation
The title block can be located in the four different corners of the print as
shown in Figure 3. The number position is relative to the feed direction into
the Folder as indicated by the arrow. The title block position into the folder
may not be the same as viewed on the workstation because the file
orientation may have been changed to accommodate the print and fold
request. There can be many reasons for this, some of which are listed
below:
Print driver settings
Media available in the printer
Fold style selected
File orientation and size defined on the workstation
Rotation
The AccXES Controller using either bi-directional communications or finisher
file information will attempt to place the title block in the folder-preferred
location for the fold style selected. If the Controller positions the title block
correctly, the title block, in most cases, will be visible on the folded print.
PRINTER
2
3
Figure 3. Title Block Orientation into the Folder
XES Synergix 8825/8830/8855 Digital Solution Folding Supplement
FOLDER
2
1
1
feed direction
3
4
4
Output Orientation
Depending on the fold style (fold program) selected, the folded package may
be delivered to the output catch bin with the title block either face down
y
or face up
. If a collation or reverse print order selection is available on
the print driver; it may be an appropriate selection to change the output.
When using ACT, the collation is based on the selected fold style and the
AccXES controller will determine the ordering of the prints.
x
Figure 4. Title Block Output Position
y
Title Block
x
3