Xerox Synergix 8830 소프트웨어 설명서 - 페이지 12

{카테고리_이름} Xerox Synergix 8830에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Synergix 8830 30 페이지. Windows nt 4.0 postscript print driver user guide
Xerox Synergix 8830에 대해서도 마찬가지입니다: 운영자 매뉴얼 (48 페이지), 설정 매뉴얼 (20 페이지), 릴리스 노트 (23 페이지), 보충 설명서 (26 페이지)

페이지 인쇄
Xerox Synergix 8830 소프트웨어 설명서
XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide
Driver Configuration (Printer Properties Dialog)

Device Settings Parameters

The Device Settings tab of the Printer Properties dialog contains a number of
configurable device settings.
Form to Tray Assignment
Manual Feed Setting - Lets you set the size of the manual feed option
on the printer if the printer is so equipped. It is recommended that you
leave this setting at the default of letter.
Roll Settings - Use these parameters to set up the driver with the sizes
of media rolls installed in the printer. For the 8855 printer there will
typically be four Rolls to set. It is recommended that you leave this
setting at the default of letter.
Font Substitution Table - Displays a list of your system-installed fonts and
the printer-resident fonts set for their replacement if you choose Substitute
with Device Font in the True Type Font parameter of the Advanced Tab of the
Document Properties Dialog as stated in this Guide.
Available PostScript Memory - Specifies the amount of PostScript memory
which is a subset of total printer physical memory. The driver uses this
information when performing printing tasks, such as sending fonts from the
computer to the printer. Unless PostScript printing problems are occurring, it
is best if the default setting of 2048 kilobytes is used. The range for this
setting is 249 to 32767KB.
Figure 3. Typical Device Settings Tab
8