Configuration & Settings Test Prints
The first task that is performed with ALL network environment setups is the printing of
Configuration and Settings test prints. You can print them using the Web Print Management Tool
or the Printer Control Panel.
Printing a Test Print
From the Web Print Management Tool:
1. On the Web Print Management Tool, select UTILITIES> Test Print.
2. Select Normal Test to get both a Configuration and Settings Test Print.
From the Printer Control Panel
(510, 8825, 8830, 8850 printers only):
CONFIGURATION Test Print
1.
While the Printer is NOT printing, at the Control Panel press the ONLINE
displayed.
2.
Press the ENTER
3.
Press the ENTER
4.
Press the ENTER
5.
Press the NEXT
Test Print.
6.
Press the ENTER
return to UTILITIES.
7.
Press the EXIT key twice and the display will return to PAUSED.
8.
Press the ONLINE
SETTINGS Test Print
Repeat Steps 1-4 above.
Step 5: Select PRINTER SETTINGS Test Print.
Repeat Steps 6-8 above.
Viewing the Test Prints
The purpose of test prints is to provide a record of current system settings for use in daily
operations, network communications setup, and restoration of desired parameters in cases of
unexpected change (such as through accidental use of the Restore Factory Default utility). Test
print sets should be saved at the following times:
When the initial install is complete and default settings are defined.
Anytime default settings are changed.
Note: For the 721 printer only, the test print is generated when the power is switched on.
The reference set of the test print pages should be stored with the machine service log.
FreeFlow Accxes Printer System and Web Print Management Tool Setup Guide
key and the UTILITIES menu will be displayed.
key and the TEST PRINT menu will be displayed.
key again and <ALL> will be displayed.
key as many times as required to choose the PRINTER CONFIGURATION
key again to enable the selected Test Print, and the displayed menu will
key to put the Printer back on line and print out your Test Print.
key. PAUSED will be
5
페이지 인쇄