Xerox Workcentre 265 보충 설명서 - 페이지 15

{카테고리_이름} Xerox Workcentre 265에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Workcentre 265 20 페이지. Xerox multifunction printers specification
Xerox Workcentre 265에 대해서도 마찬가지입니다: 참조 매뉴얼 (27 페이지), 설치 매뉴얼 (2 페이지), 사양 (21 페이지), 평가자 매뉴얼 (27 페이지), 빠른 매뉴얼 (21 페이지)

페이지 인쇄

Select On and Save.

The Build Job Controls

button will appear on the

Basic Copying screen.

Place the first segment of

the body of the original in the

Document Handler.

Select the tray that contains

the body stock.

Select your required 1 or 2-sided option and any other settings for this

segment.

Press Start. The first segment will be scanned to memory.

Place the first tab divider face down on the document glass aligned to the rear

right hand corner and close the Document Handler.

Select the tray that contains the tab stock.

Select 1 - 1 sided copies.

Press Start. The divider will be scanned.

Repeat this process until all the segments of the document have been

scanned. Don't forget to make the appropriate selections for each segment. If

you make a mistake, select the Build Job Controls button and select Delete the

Last Segment. Scan the segment again.

When all the segments have been scanned, select Build Job Controls.

Select End Build Job. The

job will be compiled and one

sample set will be printed.

If the sample set is OK select

the Job Status button on the

control panel, locate the job

in the job queue and select

Release.

When printing is complete select the Clear All button to reset the machine to

the default settings.

Note:

Xerox CopyCentre, WorkCentre, WorkCentre Pro 232/238/245/255/265/275 Tab Supplement

In the unlikely event of a paper jam occurring, follow the instructions on the

screen and remove any partially used sets of tab stock from the paper

tray.

4 Copying using Build Job