Xerox DOCUCOLOR 12 매뉴얼 사용 - 페이지 10

{카테고리_이름} Xerox DOCUCOLOR 12에 대한 매뉴얼 사용을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DOCUCOLOR 12 12 페이지. Carrier
Xerox DOCUCOLOR 12에 대해서도 마찬가지입니다: 사양 (2 페이지), 참조 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (8 페이지), 보충 설명서 (4 페이지), 보충 설명서 (18 페이지), 매뉴얼 알아보기 (24 페이지)

O REASSEMBLE THE

Power switch

Power connector

Mouse

Keyboard

Monitor

Copier interface (scan)

Copier interface (print)

(not used)

10/100BaseT

Using the Fiery X12/Fiery X40 Advanced Controller Interface Kit

X12/F

IERY

1. Reseat all boards, cables, connectors, and other parts loosened or removed during

inspection or service.

2. Place the Fiery X12/Fiery X40 in its standard operating position.

3. Place the side panel onto the Fiery X12/Fiery X40 so the grooves on the bottom of the

side panel ﬁt into the grooves in the tray.

Be careful not to damage any ribbon cables; if necessary, fold the ribbon cables inside the

tray before replacing the side panel.

4. Close the side panel. Two clips on the top edge of the panel will click when it is properly

installed.

5. Replace the screw that secures the side panel.

Do not leave the Fiery X12/Fiery X40 side panel off after servicing. An airﬂow

OTE

channel is created by the side panel and the fan. Leaving the Fiery X12/Fiery X40 open

could reduce the operational life expectancy of internal Fiery X12/Fiery X40

components.

6. Connect any cables removed during service to the back of the Fiery X12/Fiery X40.

7. Connect the monitor, keyboard, and mouse to the back of the Fiery X12/Fiery X40.

8. Connect the monitor power cable to the back of the monitor (some monitors may already

have this cable attached).

X40