Xerox DocuPrint 180MX 사용자 설명서 - 페이지 9
{카테고리_이름} Xerox DocuPrint 180MX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint 180MX 40 페이지. Freeflow print server micr user guide
Xerox DocuPrint 180MX에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (32 페이지)
페이지 인쇄
Media for the MICR fonts
MICR fonts installation
Installing PostScript and PCL fonts
MICR User Guide
MICR Fonts CD-ROM
The PostScript, PCL, and LCDS MICR fonts are provided
on two CD-ROMs—one for 300 dpi printing and one for
600 dpi and above. The two CDs contain the same fonts
except for the following:
·
The 600 dpi MICR Fonts CD contains the E13B9 and
E13B PostScript 600 dpi fonts.
·
The 300 dpi CD contains a 300 dpi version of the
E13B PostScript font. It does not contain E13B9,
which is 600 dpi only.
Note: When loading your fonts from CD, load the fonts
from either the 600 dpi MICR Fonts CD or the 300 dpi
CD. If both versions of the 9.12 point E13B PostScript
font are present on the system at the same time,
unpredictable results can occur. For this reason, two CDs
are provided, each containing a different version of the
9.12 point E13B PostScript font.
If you have loaded your MICR fonts from the 600 dpi CD
and you want to print using the 300 dpi PostScript MICR
font, you must first delete the 600 dpi E13B.PFB font, then
reload the 300 dpi E13B.PS font from the 300 dpi CD.
If fonts were loaded from the 300 dpi CD, delete the 300
dpi E13B.PS font before loading the 600 dpi E13B.PFB
font. (Refer to "Installing PostScript and PCL fonts," later
in this chapter, for the font loading procedure.)
Media for IPDS fonts
AFP MICR fonts, supporting the IPDS datastream, are
provided at 300 dpi on various media (CD, cartridge tape,
or diskette). Follow instructions for your host system for
loading these fonts on the host.
To install the PostScript and PCL fonts, follow these
steps.
1. Log in at the Administrator level.
2. Insert the "DocuPrint MICR Fonts" CD into the CD-
ROM drive.
3. Click the Administration icon on the main DocuSP
window.
MICR fonts
2-3