Xerox DocuPrint 180MX 사용자 설명서 - 페이지 9

{카테고리_이름} Xerox DocuPrint 180MX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint 180MX 32 페이지. Freeflow print server micr user guide
Xerox DocuPrint 180MX에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (40 페이지)

페이지 인쇄

MICR fonts installation

MICR User Guide

NOTE: When loading your fonts from CD, load the fonts from

either the 600 dpi MICR Fonts CD or the 300 dpi CD. If both

versions of the 9.12 point E13B PostScript font are present on the

system at the same time, unpredictable results can occur. For this

reason, two CDs are provided, each containing a different version

of the 9.12 point E13B PostScript font.

If you have loaded your MICR fonts from the 600 dpi CD and you

want to print using the 300 dpi PostScript MICR font, you must first

delete the 600 dpi E13B.PFB font, then reload the 300 dpi

E13B.PS font from the 300 dpi CD.

If fonts were loaded from the 300 dpi CD, delete the 300 dpi

E13B.PS font before loading the 600 dpi E13B.PFB font. Refer to

"Loading PostScript fonts," later in this chapter, for the font loading

procedure.

Media for IPDS fonts

AFP MICR fonts, supporting the IPDS datastream, are provided at

300 dpi on various media (CD, cartridge tape, or diskette). Follow

instructions for your host system for loading these fonts on the

host.

Installing PostScript and PCL fonts

To install the PostScript and PCL fonts, follow these steps.

1. Log in at the Administrator level.

2. Insert the "MICR Fonts" CD into the CD-ROM drive.

3. Select the Administration pull-down menu on the main print

server window.

4. Select the PostScript/PDF/PCL Fonts tab.

5. If PostScript MICR fonts are needed, perform the following

steps.

NOTE: Make sure that you are loading the appropriate CD for the

font resolution (300 or 600 dpi) that you want.

If you do not need PostScript MICR fonts, skip to step 6 for

instructions on loading PCL MICR fonts.

a. Select PostScript Soft from the Font Type pull-down menu.

the Load... button. The Install Postscript Soft Fonts

Click

window opens.

c. From the Look In... pull-down menu, select DOS CD-RW

d. Click List Fonts. In the Files section, the MICR fonts on