Xerox FreeFlow 릴리스 노트 - 페이지 15

{카테고리_이름} Xerox FreeFlow에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox FreeFlow 33 페이지. For color 560/570 printer
Xerox FreeFlow에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 브로셔 (2 페이지), 릴리스 노트 (23 페이지), 설치 매뉴얼 (2 페이지), 보안 매뉴얼 (38 페이지), 중요 설치 정보 (2 페이지), 사용자 설명서 (50 페이지), 매뉴얼 (18 페이지), 빠른 연결 매뉴얼 (2 페이지), 항공사 절차 매뉴얼 (28 페이지)

8.1.1.3

USING ON DEMAND IMAGE OVERWRITE (ODIO)

The On Demand Image Overwrite (ODIO) feature is designed to clean the system after it has

been used by overwriting the entire HDD and is activated by pressing the "Start" button on the

Security Feature Web Pages shown below. After pressing the "Start" button, the AccXES

controller will post a message to the Printer UI display (if there is one) and then reboot. The HFT

and PUN controllers will indicate the progress of the operation via the LED's on the front panel.

The printer UI on the 510, 8850, 8830, and 8825 will also display progress. The WebPMT and

scanner UI will NOT be active until the operation is complete.

When the ODIO operation is complete, the controller will print a status page and then resume

normal operation.

An ODIO is a lengthy operation. Approximates times for an ODIO are listed in the table below:

HDD

Size

20GB

40GB

80GB

NOTE: If you have done an ODIO, it is important that you do NOT refresh the Web page after the

system reboots because the refresh will resend the "ODIO Request" and cause the system to

perform another ODIO.

Page 15

Controller Type

HFT/PUN

30 Minutes

45 Minutes

90 Minutes