Xerox Nuvera 100 보충 설명서 - 페이지 38

{카테고리_이름} Xerox Nuvera 100에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Nuvera 100 48 페이지. Production system
Xerox Nuvera 100에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 기능 설명서 (34 페이지), 계획 매뉴얼 (22 페이지), 사용자 설명서 (40 페이지), 운영 매뉴얼 (34 페이지), 참조 매뉴얼 (2 페이지), 계획 매뉴얼 (20 페이지), 참조 매뉴얼 (42 페이지), 빠른 참조 (2 페이지), 설치 매뉴얼 (2 페이지), 계획 매뉴얼 (38 페이지), 계획 매뉴얼 (16 페이지), 참조 매뉴얼 (2 페이지), 사양 (2 페이지), 힌트 및 팁 매뉴얼 (18 페이지), 힌트 및 팁 매뉴얼 (18 페이지), 시작하기 매뉴얼 (26 페이지), 시작하기 매뉴얼 (30 페이지)

Managing and printing jobs from the Tape Client

Starting and ending tape dump sessions

2-14

To print a dump of an offline job that you wish to troubleshoot,

follow these steps:

1. Specify the desired JDE and the DUMP JDL on the Tape

Client window at the controller. (The DUMP JDL, which was

loaded on your system at installation, specifies the VOLUME

HOST=DUMP command and carious JDEs for different types

of hosts.)

2. Change the properties of the queue that was specified for the

job for which you are printing the dump, as follows:

a. On the Queue Manager window, double-click the name of

the queue that was specified for the tape job, to open the

Properties window for that queue.

b. Click the Properties tab, and select Spooling in the Input

group box.

c. Click the Output tab, and select Head-to-Toe in the Sides

Imaged group box, and ASCII in the Format field.

d. Click the ASCII tab, and select the following:

•

Font size

•

Landscape orientation

(For further information on procedures for setting up a queue,

click Help on the Queue Manager window.)

3. Run the job that you want to troubleshoot.

4. Terminate the dump session by clicking End on the Tape

Client window.

5. Restore the original settings to the queue, or set up a

separate dump queue to avoid constant modifications.

For an overview of the content of a tape dump, refer to "Offline

dump format," in the "Overview" chapter of this guide.

Tape Client Job Submission Guide