Xerox Phaser 6100DN 매뉴얼 - 페이지 22

{카테고리_이름} Xerox Phaser 6100DN에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 6100DN 34 페이지. Disk overwrite installation and usage
Xerox Phaser 6100DN에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 사양 (2 페이지), 사용자 설명서 (32 페이지), 브로셔 및 사양 (4 페이지), 사용자 설명서 (28 페이지), 설치 매뉴얼 (2 페이지), 보안 매뉴얼 (38 페이지), 설치 매뉴얼 (2 페이지), 릴리스 노트 (2 페이지), 시작하기 매뉴얼 (37 페이지), 매뉴얼 (34 페이지), 시작하기 매뉴얼 (34 페이지), 사용자 설명서 (32 페이지), 설치 및 운영 매뉴얼 (8 페이지)

PCL Features and Additions

¨ The PCL tab in the Properties for a Queue has been

enhanced as follows.

¨ Operators may now save PCL resources on a job-by-job

basis, allowing for more routine saves. Previously, the save

resource function only occurred when the DocuSP controller

was shutdown.

¨ Operators may define the custom stock size for PCL custom

jobs in the job properties. This option introduces the ability to

define any size image for decomposition.

¨ A new check box allows the operator the ability to

automatically center custom sized stock in a manner similar

to the HP product line. When this feature is disabled, the

image is oriented to the side of the paper. This feature

provides HP 8100 bypass tray compatibility.

¨ The default line termination settings for PCL jobs can now be

set on the DocuSP UI. Previously, the line termination

settings had to be changed using a UNIX script.

¨ Line termination settings should not be used in a mixed PCL

and ASCII environment, because PCL data streams can

include other line termination escape sequences which could

change the line termination sequence without the operator's

knowledge.

¨ DocuSP 3.7x now supports HP PJL. Key features are

enabled for PJL data streams and include:

PJL Set Paper = Executive, Letter, A4, Legal, A3,

Ledger, Monarch, DL, C5, COM10, A5, Eurolegal, 14x17,

B5, JISB4, JISB5, Hagaki, Ohagaki, ISOB4, and Custom

PJL Set Duplex = Off, On

PJL Enter Language = PCL and PCL XL

PJL Set Binding = Longedge, Shortedge

¨ The operator may set the system to ignore PJL commands.

This emulates the behavior of prior releases.

DocuSP 3.6 to 3.7 Differences Document