Xerox Phaser 6100DN 매뉴얼 - 페이지 33

{카테고리_이름} Xerox Phaser 6100DN에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 6100DN 34 페이지. Disk overwrite installation and usage
Xerox Phaser 6100DN에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 사양 (2 페이지), 사용자 설명서 (32 페이지), 브로셔 및 사양 (4 페이지), 사용자 설명서 (28 페이지), 설치 매뉴얼 (2 페이지), 보안 매뉴얼 (38 페이지), 설치 매뉴얼 (2 페이지), 릴리스 노트 (2 페이지), 시작하기 매뉴얼 (37 페이지), 매뉴얼 (34 페이지), 시작하기 매뉴얼 (34 페이지), 사용자 설명서 (32 페이지), 설치 및 운영 매뉴얼 (8 페이지)

DocuSP 3.6 to 3.7 Differences Document

limited by the available hard disk space. The entire job must

be spooled to disk before the decomposer can begin ripping.

Auto End changes and moves

¨ In previous versions, the operator needed to press "Start" to

start an online job and press "End" to finish the job. The

operator needed to be present to press "End" so that network

jobs could be scheduled and printed.

¨ The AutoEnd feature allows:

¨ Online jobs to automatically end and start based on a timer

set in the Online Gateway configuration.

¨ Online jobs automatically end and start based on the receipt

of the channel command 0x6b (raise cover) in the

datastream.

¨ Now the AutoEnd feature invokes the "End" for the current

job and starts a new job without operator intervention.

¨ The System Administrator enables AutoEnd. By default, the

AutoEnd feature is disabled.

¨ AutoEnd is supported in both streaming and spooling modes.

¨ AutoEnd and AutoDrain with a timer cannot be set at the

same time.

¨ A popup message prompting the operator to save the current

job setup will no longer display when an operator exits online

manager.

¨ To save a job setup to a file, the operator will have to select

the Save or Save As button in the online manager window.

¨ Image shift is supported for LCDS jobs on the DocuPrint

75/90 and on DocuPrint 1xx EPS printers.

¨ Image shift changes must be applied before the job is sent.

Any changes made while a job is printing are not honored

until the next job.

¨ If the operator shifts the image too far in a negative direction,

the image may be cropped.

¨ The Aux, Main, and Auto stock definitions are available in the

Stock Library and cannot be deleted from the system.