Xerox Phaser 6100DN 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} Xerox Phaser 6100DN에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 6100DN 8 페이지. Disk overwrite installation and usage
Xerox Phaser 6100DN에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 사양 (2 페이지), 사용자 설명서 (32 페이지), 브로셔 및 사양 (4 페이지), 사용자 설명서 (28 페이지), 설치 매뉴얼 (2 페이지), 보안 매뉴얼 (38 페이지), 설치 매뉴얼 (2 페이지), 릴리스 노트 (2 페이지), 시작하기 매뉴얼 (37 페이지), 매뉴얼 (34 페이지), 매뉴얼 (34 페이지), 시작하기 매뉴얼 (34 페이지), 사용자 설명서 (32 페이지)

3. If there are active jobs in the system, a warning message is displayed that all active jobs are deleted.

Select [OK].

4. The Data Overwrite screen is displayed. All Active Jobs, Completed Jobs, and Logs are automatically

overwritten. Select the Overwrite Additional Items option if desired.

•

Selecting Saved Jobs Only also overwrites all saved jobs in the /var/spool/XRXnps/saved directory.

•

Selecting Saved Jobs and User-Added Resources also overwrites all additional resources, such as

fonts or forms.

5. Select the Use Fast Mode option if desired. The Use Fast Mode option runs the Disk Overwrite process in a

single write pass only plus sample or full verification.

6. Select [OK].

7. The DocuSP interface and the Solaris operating system are shut down.

8. The system is rebooted into single user mode and requests the root password. Enter the root password, then

press <Enter>.

9. A warning message is displayed asking if you are sure you want to start the Data Overwrite. Type Y and

press <Enter>.

10. The Disk Overwrite process starts.

11. If for some reason the process needs to be halted, press <CTRL> <C>.

12. When the Disk Overwrite process has successfully completed, the system reboots.

13. Some DocuSP printer products, such as the Nuvera 100/120, DocuTech 75/90, DocuPrint 75/90, or

DocuPrint 75MX, have an image disk in the printer itself. In these cases, the image Disk Overwrite process is

automatically started in parallel with the system Disk Overwrite process.

14. After the overwrite is complete, the system reboots and the DocuSP interface restarts.

NOTE: For the Nuvera 100/120 printers, the system powers down after completion of the overwrite process.

The customer needs to power up the system afterward. If the customer is running DocuSP 50 or later on a

Sun W1100Z controller, the customer needs to press <CTRL><D> when prompted to exit out of the single

701P45144

June 2006