Caley Coaches CL02/2a 구축 지침 - 페이지 7
{카테고리_이름} Caley Coaches CL02/2a에 대한 구축 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Caley Coaches CL02/2a 12 페이지. Caledonian railway classes 812 & 652 0-6-0 locomotives
페이지 인쇄6.9
Shape the cab roof (part 12) by bending over a suitable pipe until it fits the shape of the hole left
in the fret after removing one of the roof stanchions (part 17). Note that the curved part is only
between the two half etched lines - the outer portions should be bent back flat with the half etched
lines to the outside of the bend (i.e. inside the cab once built.)
6.10
Solder the roof centre strip (part 15) in place on the roof after forming to the roof shape and then
solder one of the roof stanchions (part 17) into the half etched groove in the centre strip. This will
help iron out any minor discrepancies in the shape of the roof.
6.11
Solder the other two stanchions to the front and rear of the roof and the front and rear strips (part
14) to the roof inside them (N.B. rear on 652 roof only).
6.12
On the 812 roof only solder form its rear stanchions (part 13) to the curve of the rear portion of
the roof and solder in place along the rear curve.
6.13
Solder the roof gutter lips (part 16) to the roof and stanchions at each side.
6.14
Fix the (cast) reversing lever on the cab floor next to the left-hand spalsher box.
6.15
There is a small tab on the bottom of the cab front which locates into a recess in the footplate at
the extremity of the rear projection into the wheel/motor well. Locate the cab on the footplate
using this as a guide and solder in place.
Caley Coaches
CL02/2a Building Instructions
Page 7