ABB SREA-01 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} ABB SREA-01에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB SREA-01 4 페이지. Ethernet adapter module

3. Connecting drive(s)

If you have a single ACS350, ACH550 or ACS550, it is easiest to

use the supplied RJ45 cable to connect to the panel port.

RX (RS-232)

TX (RS-232)

If you have multiple drives or an ACS800, use the RS-485

connection. Connect the A- channels of the SREA-01 unit and the

drives together, the B+ channels together and the COM connector

to the data ground connectors of the drives. Use 120 ohm

terminating resistors in the network.

4. Basic drive settings

Check the communication settings of the drive (either group 52 or

53 in most drives, depending on the connection type).

Station id/number has to be unique for each drive! The baud rate

selection and parity have to be same on all drives and

SREA-01. You can use for example 9600 bit/s, no parity, 1 stop bit.

5. Basic SREA-01 settings

You can change the Ethernet settings under Setup – Ethernet.

Select the correct drive connection settings under Setup –

Modbus.

• Select Physical Interface.

• Usually most other settings are suitable by default (RTU,

9600 bps, no parity, 1 stop bit).

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01

X1 pin

COM

orange and blue

X1 RS-232:

X1 RS-485:

X2:

Wire

white-orange

white-blue

Select EIA-232

Select EIA-485

Select EIA-232 D-sub

SREA-01 Quick Start-up Guide

Panel port

RJ45 pin

2 and 6