Direct Supply EZ-LIFT WHEELCHAIR SEAT 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Direct Supply EZ-LIFT WHEELCHAIR SEAT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Supply EZ-LIFT WHEELCHAIR SEAT 20 페이지.
페이지 인쇄Adjusting Seat Collapse Force Setting
Follow these steps for fine-adjustment of seat collapse force. Use this setting if the wheelchair user
requires a lower force to lower the seat while sitting, while maintaining a higher lifting force while
standing. Primary lift force adjustment should be done using the main lift force adjustment described in
the previous step.
•
WARNING: Do not attempt to adjust force while the wheelchair or lift seat is occupied.
a. Access the collapse force adjustment by
removing the bottom strap of the front cover,
as shown. (figure 23)
b. Adjust seat collapse force by using a 3/16
inch hex wrench to turn the counterbalance
adjustment screw to the desired position.
The screw may be set at any position, as
desired. (figure 24)
Turn screw CLOCKWISE
Screw is fully inserted
Turn screw
COUNTER-CLOCKWISE
Screw is backed-out
•
WARNING: Do not force screw past its
maximum settings in either direction.
c. Once the desired force setting has been
selected, replace the front cover lower strap.
d. Allow the user of the wheelchair to test the
seat force. Ensure that the seat is providing
stability while sitting and force assistance while
standing. If necessary, make adjustments to
the force setting based on user's preference.
14
Directions for Use
HIGHER force to
=
start to collapse
seat
LOWER force
=
to start to
collapse seat
(cont.)
Figure 23
Figure 24