Alderon Industries Oil Alert VA02 운영, 유지보수 및 설치 매뉴얼 - 페이지 4
{카테고리_이름} Alderon Industries Oil Alert VA02에 대한 운영, 유지보수 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alderon Industries Oil Alert VA02 4 페이지. Alarm panel
페이지 인쇄
Oil Alert Remote Alarm
TM
Alarm Panel Model VA02 Operation, Maintenance
and Installation Manual
Installation of the Oil Alert Remote Alarm Continued
6. Connect the Oil Alert Remote Alarm to the auxiliary contacts marked
COWT in the control panel. Use 18 awg, 3 conductor cable. CAUTION:
The auxiliary cotacts are low voltage wires and con not be run in a
conduit with High voltage wires.
6. Plug in the power supply into a 120VAC, 50/60 HZ
standard wall outlet. The green "Normal" light should
come on.
7. Test the system by pressing the "Test" switch or by activating
the "signaling device". The buzzer and the red warning light will be
"on". Press the "Silence" switch. The buzzer will silence but the
alarm light will remain "on". Deactivate the "signalling device." The
alarm light will turn "off". Since the Oil Alert Remote Alarm is
equipped with "Auto Reset", reactivating the "signaling device" for
a new test cycle will reactivate the buzzer and alarm light. Test
product weekly to ensure system integrity.
Alarm Systems
Control Panels
PO Box 827
Hawley, MN 56549
O W
Float Switches
Leak Detection Systems
(218) 483-3034
Fax (218) 483-3036
Connects To
Auxiliary Contacts In
Panel
C O W
5 ft max
P/N
www.alderonind.com
Page 4 of 4