Alderon Industries VLIO-00004 사용자 설명서 - 페이지 7

{카테고리_이름} Alderon Industries VLIO-00004에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alderon Industries VLIO-00004 20 페이지. Indoor/outdoor alarm panel

Wall Mounting Enclosure (continued)

STEP 3: MOUNT ENCLOSURE

Determine the mounting location for the VersAlarm™ I/O. Hold

the VersAlarm™ I/O up to the desired mounting location, mark

the drill hole locations. Once marked, drill pilot holes for screws

(not included) and use wall mount anchors (not included) if nec-

essary. Place enclosure in the mounting location, adjust until

the pilot holes are lined up with the enclosure and fasten screws

to secure the alarm panel in place.

Wiring

STEP 1: WIRING

The wiring diagram shows six terminals on the terminal block

that consists of three pairs of connections.

1) Starting from the right, the first pair of terminals (5 and

6) are for the power mains. The first line connection (L1)

is installed in terminal 5 and second line connection (L2)

is installed in terminal 6.

2) The second pair of terminals (3 and 4) are for the sensor

connections. The sensor is typically a float switch, but

most digital switch sensors will work with the sensor

input.

3) The third pair of terminals (1 and 2) are for the auxiliary

contacts. This connection can be used on most digital

peripheral alarm monitors or extensions.

4) NEVER leave ground wire exposed inside the panel, use

provided Wago connector for ground termination. See

step 2 for installing wire into Wago connector.

VersAlarm™ I/O - USER GUIDE

Alderon Industries™ - Leading Edge Control Products | 7

AUX

SENSOR

POWER

1 2 3 4 5 6

WAGO