Direct Supply Panacea 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Direct Supply Panacea에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Supply Panacea 2 페이지. Air ease mattress
Direct Supply Panacea에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (5 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (5 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Introduction

Thank you for purchasing this Panacea Lightweight Wheelchair. In

this owner's manual, you'll find important information that you should

read before assembling and using this device. If at any time you do

not understand how to use this product, or you suspect it may be

damaged, DO NOT USE and immediately contact the distributor that

sold this product to you. This owner's manual is compiled from the latest

specifications and product information available at the time of publication.

Changes may be made to this manual at any time. Contact your distributor

for a current copy of this owner's manual.

Definitions and Symbols

NOTE: Indicates a tip.

• CAUTION: Means correct operating or maintenance procedures must

be followed in order to prevent damage to or destruction of the product or

other property.

• WARNING: Calls attention to a potential danger that requires correct

procedures or practices in order to prevent personal injury.

PRODUCT or DEVICE: Your Panacea Lightweight Wheelchair, distributed

by Direct Supply Manufacturing, Inc.

Warnings and Cautions

Read carefully all directions and warnings before using this device. Do not

operate this device without first reading and understanding the contents of

this manual. Death or injury may result from the improper use of this device

or failure to follow all directions and warnings. This device is intended for

use in normal, indoor conditions. This product may not be appropriate for all

individuals.

• WARNING: This wheelchair has not been approved as a seat that can

be used within vehicles of any kind. Always transfer wheelchair user to a

vehicle manufacturer-approved seat and use available safety restraints.

• WARNING: Do not operate this wheelchair on roadways, streets or any

surfaces with vehicular traffic.

• WARNING: Do not attempt to operate on inclines 10 degrees or greater

without proper assistance.

• WARNING: Be sure to completely engage wheel locks when getting in

and out of wheelchair or when in elevator or wheelchair lift.

• WARNING: Wheelchair locks should be used only when the wheelchair

is at a complete stop. The locks are not intended to be used when the

wheelchair is moving. Do not use locks as brakes to slow down.

• WARNING: Wheelchair should be on a smooth, stable and level area with

wheel locks engaged before transferring user into or out of wheelchair.

• WARNING: Do not adjust footrests any lower than 2

• WARNING: When getting in or out of wheelchair, do not stand on or

apply weight to footrests.

• WARNING: Before reaching or leaning forward, rotate casters to front

of wheelchair and engage wheel locks to help prevent wheelchair from

tipping over.

• WARNING: Do not lean out of the chair or apply weight to the top of

wheelchair back. This can cause wheelchair to tip over. When trying to

extend arms over back, only allow residents to reach as far as their arm can

extend without having to alter their seating position.

• WARNING: Do not stand on wheelchair.

• WARNING: Abruptly stopping or changing directions while going up or

down an incline could cause instability or possible tipping over.

• WARNING: A skilled caregiver should assess the appropriateness of

removing footrests or legrests on a case-by-case basis.

• WARNING: Always provide assistance to residents transferring into and

out of this device.

• WARNING: Do not make any modifications to this device or use

non-Panacea parts. Doing so may void the warranty and pose a risk to

the resident.

• CAUTION: State and local codes and regulations may prohibit

the removal of footrests. Check with your local authorities to ensure

compliance with all applicable regulations.

• WARNING: This device may not be suitable for all individuals. A skilled

caregiver should always assess the appropriateness of this device for a

resident on a case-by-case basis.

Wheel locks: Engage both wheel locks before getting into or out of chair,

leaning forward in chair, or while in an elevator or wheelchair lift. Proper

adjustment of wheel lock is at least

by pushing handle completely forward. Adjustments to locks are made by

loosening or tightening the nut on the carriage bolt. Embed lock to show

at least

⁄

" by sliding clamp toward rear wheel while handle is in locked

position. Test for correct locking action and the resident's ability to engage

wheel locks before each use.

Tires: The solid rubber tires on your Panacea wheelchair need minimal

maintenance but should be cleaned occasionally with a damp cloth.

Replace if tires become severely worn or if cracking appears.

Front casters: Casters should be checked periodically and lubricated

occasionally. Lubricate by removing fork and greasing caster stem bearings.

Lubricate wheel bearings by removing wheel from fork. Reassemble fork and

wheel by tightening nuts until no play remains, but wheels roll freely. If nut is too

loose, caster will shimmy. If nut is too tight, the chair will be difficult to steer.

Removal of swingaway footrests/legrests: Release lock by pushing on the

front rigging lever. Swing footrest/legrest out and sideways. Lift to remove.

Adjusting length of footrest/legrest: When adjusting length of footrests

or legrests, user should be sitting in wheelchair with feet on the footplates.

Loosen bolt on the clamp around support assembly. Raise or lower footplate

to desired position, taking into account the support of thighs. Front rigging

⁄

" from floor.

should not be so low that it causes uncomfortable pressure to thighs at front

of seat upholstery. Footrest should not be lower than 2

ensure clearance.

Directions for Use

⁄

" when locked. Locks are engaged

⁄

" from the ground to

1-800-634-7328

DirectSupply.com

Adjusting/elevating legrest: Lift footplate on legrest assembly to

desired position. Release legrest assembly and it will automatically

lock into place. To lower, push out on legrest lever and lower

footplate to desired position.

Wheels: Large rear wheels should be inspected at least once a

month to ensure proper tightness. If wheel wobbles or is loose,

release lock nut and tighten axle bolt slightly. Test for proper

tightness by leaning chair to one side and spinning adjusted wheel.

General care: Wipe chrome parts with a clean, soft cloth at least

once a week. All metal parts can be cleaned with auto wax or similar

devices. If exposed to moisture, dry immediately. Do not use an

abrasive cleanser that will scratch the finish.

To open chair: Open wheelchair by tilting to one side and pushing

down on seat rail until fully opened.

To close/fold chair: First, fold footplates to vertical position. Grab

seat with both hands at front and back edge and lift, or tilt chair to

one side and lift up on seat rail.

To remove arms: Remove arms by depressing spring button and

lifting arms out of front and rear sockets.

To adjust seat depth: Unfasten Velcro

on the bottom front seat

section. Using Allen wrench provided with the chair, completely

remove two screws from the front of the seat frame. Move

telescoping seat frame supports to the desired seat depth. Reinstall

screws. Fasten Velcro to complete seat adjustment process.

Seat Extension Instructions

Your Panacea wheelchair comes with an adjustable depth seat that

has been factory set at the shortest position. Follow the instructions

below to extend the seat depth of your chair.

1. Lay wheelchair on its back. Open seat two-

thirds of the way so seat posts do not rest on

chair frame. Unfold seat extension by pulling

upward on end of seat to release Velcro (Fig. 1).

2. Pull outward on Velcro strips to free them

from underside of seat (Fig. 2).

3. The seat extension post is located inside the

seat frame. To access it, turn screw counter-

clockwise and remove it (Fig. 3).

4. Pull upward on seat extension post until

the second hole on the seat post lines

up with the hole on seat frame. Reinsert

screw into bottom hole and turn clockwise

to secure in place (Fig. 4).

5. Fold Velcro closure strap over extended seat post

to secure seat upholstery to the frame (Fig. 5).

6. Repeat process for opposite side (Fig. 5).

7. Return chair to upright position and push down

on seat to secure it to the frame (Fig. 6).

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6