Alderon Industries VertiMAC VM13 Series 사용자 설명서 - 페이지 11

{카테고리_이름} Alderon Industries VertiMAC VM13 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alderon Industries VertiMAC VM13 Series 20 페이지. Pump switch

VertiMAC™ Pump Switch - USER GUIDE

Additional Assembly and Product Information

This VertiMAC™ pump switch model comes pre-assembled with the actuator rod, float, and pipe clamp bracket installed. The

pumping differential is set at the maximum range (6.0"). If adjustments or servicing is required, use this section for additional

instructions on the VertiMAC™ pump switch.

MOUNTING PIPE CLAMP BRACKET

Place the pipe clamp bracket on the bottom of the VertiMAC™

pump switch housing and line up the holes. Use a #2 phillips

head screwdriver to securely fasten the bracket to the housing

with provided screws.

INSERTING ACTUATOR ROD

Slide the actuator rod arm upward into the front of the VertiMAC™

pump switch housing, positioned so the notch on the actuator arm

matches the side of the housing with the hole. If the actuator rod

arm is inserted in the correct position, the pump switch housing

should make a clicking sound as the rod slides up and down.

ACTUATOR PIN PLACEMENT

Once the actuator rod arm has been placed into the VertiMAC™

pump switch housing in the up position, insert the actuator pin

into the small hole on the left side of the housing until it snaps

in place.

Alderon Industries™ - Leading Edge Control Products | 11