aerauliqa QR100M 설치 매뉴얼 - 페이지 12

{카테고리_이름} aerauliqa QR100M에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aerauliqa QR100M 16 페이지. Heat recovery ventilation unit

페이지 인쇄

8.4 Service

Make sure that the mains supply to the unit is disconnected before performing any installation, service, maintenance or electrical work!

The installation and service of the unit and complete ventilation system must be performed by an authorized installer and in accordance with local rules and

• Keep the unit surface free from dust.

• Clean the filters every three months with a vacuum cleaner and replace the filters every year. This may differ per situation depending on internal and external

environmental conditions (fig.8 g-h-i-j-k).

• Clean the heat exchanger every year with a vacuum cleaner. This may differ per situation depending on internal and external environmental conditions and

on frequency of filter cleaning. To remove the heat exchanger unlock the specific bracket by turning the yellow screw (fig.8 g-h-l-q-r).

• Clean the fans every year with a vacuum cleaner. This may differ per situation depending on internal and external environmental conditions and on frequency

of filter cleaning. Do not move the balance clips (fig.8 g-h-l-m-n-o-p).

• Check the condensation drainage: remove the front covers and, if necessary, clean the condensation tray. Check the U-bend efficiency.

Fig. 8.g

Fig. 8.i

Fig. 8.k

Fig. 8.m

WARNING

regulations.

Fig. 8.h

Fig. 8.j

Fig. 8.l - max fastening torque 0,4Nm

Fig. 8.n