eControls Smart WHF Control WTTK 설치 관리자 매뉴얼 - 페이지 2
{카테고리_이름} eControls Smart WHF Control WTTK에 대한 설치 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. eControls Smart WHF Control WTTK 4 페이지. Whole house fan wall control
페이지 인쇄Step 4. Feed Cable to Gang Box
If the optonal TS3J Outdoor Temperature Sensor is
being installed, install it now. (See the TS3J Installer
Guide.)
Feed the other ends of the cable from
the FC3J and the TS3J (if installed)
through the wall and the opening in the
gang box. Insert the gang box into the
wall opening and secure.
Step 5. Connect Cable to the WTT
Connect the other end of the "RED" Plug&Play cable into
the"RED" connector on the back of the WTT wall control.
Connect to
"RED"
connector on
back of WTT
If a sensor is installed, connect the cable with the "YELLOW"
marker into the "YELLOW" connector.
Step 6. Power the Fan
Apply power to the fan. If the fan automatically starts up,
remove power and check the wiring. If the problem persists,
contact us.
Verify that the WTT Wall Control LCD is displaying, indicating
the the WTT is receiving power.
Step 7. Attach the WTT and Wall Plate
Attach the WTT wall control to the plastic gang box using the
screws provided. Attach the wall plate to the WTT using the
screws provided in the wall plate.
Step 8. Set the Number of Fan Speeds
The WTT is factory set to a two speed fan. For three-speed or
one-speed fan installations, the number of fan speeds available
needs to be changed to reflect the type of fan installed.
To change the number of speeds, PRESS and HOLD
until the first option is displayed. PRESS
display the number of speeds. PRESS
fan or PRESS
to set a 1-speed fan.
Step 9. Checking the Installation
CHECK FAN OPERATION
PRESS
then press
MODE
PRESS
to turn the fan ON. Fan should be running.
ON/OFF
CHECK FAN SPEEDS
Verify that the fan is running in High speed. For a 3-Speed fan,
PRESS
SPEED
then PRESS
to Medium (M). PRESS
SPEED
the fan speed to Low (L). PRESS
to return to High (H) speed.
For a 2-Speed fan, PRESS
lower the fan speed to Low (L). PRESS
PRESS
to return to High (H) Speed.
PRESS
to turn the fan OFF.
ON/OFF
RETURN TO TEMPERATURE CONTROL
MODE
PRESS
then PRESS
TEMPERATURE CONTROL.
MODE
again to
MODE
to set a 3-speed
to select TIMER CONTROL.
to lower the fan speed
then PRESS
to lower
then PRESS
SPEED
then PRESS
SPEED
then
SPEED
to select
to