eControls RT2 주택 소유자 및 설치자 매뉴얼 - 페이지 8
{카테고리_이름} eControls RT2에 대한 주택 소유자 및 설치자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. eControls RT2 12 페이지. Wireless whf control
eControls RT2에 대해서도 마찬가지입니다: 사용자 및 설치 관리자 매뉴얼 (8 페이지)
페이지 인쇄Wiring FC3J to 1-Speed PSC or ECM
For 1 speed WHFs, the red and yellow wires are not
used and need to be cut off at the PC board. Use wire
nuts to connect the FC3J wires to the WHF wires and
the incoming 120VAC power wires. Orient the FC3J and
electrical box as shown.
Model FC3J
FC3J Wire
Connects
High Speed (Purple)
WHF High Speed (Black)
Med Speed (Yellow)
Not Used. CUT OFF AT PCB
Low Speed (Red)
Not Used. CUT OFF AT PCB
Neutral (White)
WHF Neutral (White) and
120VAC Neutral (White)
Ground (Green)
WHF Ground (Green) and
Power Ground (Green)
120VAC (Black)
Power 120VAC (Black)
INSTALLATION
Wiring FC3J to 2-Speed PSC
For 2-speed WHFs, the yellow wire is not used and
needs to be cut off at the PC Board. Use wire nuts to
connect the FC3J wires to the WHF wires and the
incoming 120VAC power wires. Orient the FC3J and
electrical box as shown.
Electrical box on WHF
Ground
screw
High Speed (Purple)
Power
Med Speed (Yellow)
Cord or
Low Speed (Red)
Romex
8
Model FC3J
FC3J Wire
Connects
WHF High Speed (Black)
Not Used. CUT OFF AT PCB
WHF Low Speed (Red)
Neutral (White)
WHF Neutral (White) and
120VAC Neutral (White)
Ground (Green)
WHF Ground (Green) and
Power Ground (Green)
120VAC (Black)
Power 120VAC (Black)
Electrical box on WHF
Ground
screw
Power
Cord or
Romex