Yamaha Arius YDP-140 소유자 매뉴얼 - 페이지 37

{카테고리_이름} Yamaha Arius YDP-140에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Arius YDP-140 44 페이지. Yamaha digital piano user's manual
Yamaha Arius YDP-140에 대해서도 마찬가지입니다: 미디 데이터 포맷 (6 페이지), 빠른 작동 매뉴얼 (2 페이지), 소유자 매뉴얼 (44 페이지), 매뉴얼 (44 페이지), (덴마크어) 사용자 가이드 (44 페이지)

페이지 인쇄

Connect the pedal cord.

6-1 Insert the pedal cord plug to the pedal con-

nector from the rear.

6-2 Attach the cord holders to the rear panel as

shown, then clip the cord into the holders.

6-3 Use a vinyl tie to take up any slack in the

pedal cord.

6-3

6-2

Connect the power cord (for

YDP-160) or power adaptor (for

YDP-140) to the unit.

YDP-160

7-1 Set the voltage selector (for models that fea-

ture a voltage selector).

127

240

Voltage Selector

Before connecting the AC power cord, check the set-

ting of the voltage selector which is provided in some

areas. To set the selector for 110V, 127V, 220V or 240V

main voltages, use a "minus" screwdriver to rotate the

selector dial so that the correct voltage for your region

appears next to the pointer on the panel. The voltage

selector is set at 240V when the unit is initially

shipped. After the proper voltage has been selected,

connect the AC power cord to the AC IN and an AC

wall outlet. A plug adaptor may be also provided in

some areas to match the pin conﬁguration of the AC

wall outlets in your area.

7-2 Connect the plug on the power cord to the

YDP-140

7-1 Connect the DC plug of the power adaptor

6-1

CAUTION

Do not bend the cord tightly when you hang the cord on

the cord hook. Otherwise, a short-circuit or ﬁre may

result.

WARNING

An improper voltage setting can cause serious damage to

this instrument or result in improper operation.

Set the adjuster.

Rotate the adjuster until it comes in ﬁrm contact with the

ﬂoor surface.

Attach the headphone hanger.

(for YDP-160 only)

Use the included two screws 5 (4 × 10mm) to

attach the hanger as shown in the illustration

below.

Keyboard Stand Assembly

rear panel connector.

to the rear panel connector, and loop cord

slack onto the cord hook so that the plug

will not be disconnected accidentally.

YDP-160/140

Owner's Manual