Yamaha Arius YDP-141 소유자 매뉴얼 - 페이지 35

{카테고리_이름} Yamaha Arius YDP-141에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Arius YDP-141 40 페이지. Owner's manual
Yamaha Arius YDP-141에 대해서도 마찬가지입니다: 미디 데이터 포맷 (6 페이지), 빠른 작동 매뉴얼 (2 페이지)

페이지 인쇄

Connect the pedal cord.

6-1 Insert the pedal cord plug to the [PEDAL] jack

from the rear.

6-2 Attach the cord holders to the rear panel as

shown, then clip the cord into the holders.

6-3 Use a vinyl tie to take up any slack in the pedal cord.

6-3

6-2

Connect the power cord (for YDP-161) or

power adaptor (for YDP-141) to the unit.

YDP-161

7-1 Set the voltage selector (for models that

feature a voltage selector).

Voltage Selector

Before connecting the AC power cord, check the

setting of the voltage selector which is provided in

some areas. To set the selector for 110V, 127V, 220V

or 240V main voltages, use a "minus" screwdriver to

rotate the selector dial so that the correct voltage for

your region appears next to the pointer on the

panel. The voltage selector is set at 240V when the

unit is initially shipped. After the proper voltage has

been selected, connect the AC power cord to the

[AC IN] jack and an AC wall outlet. A plug adaptor

may be also provided in some areas to match the

pin configuration of the AC wall outlets in your area.

7-2 Connect the plug on the power cord to the

rear panel connector.

7-2

7-1

6-1

127

240

YDP-141

7-1 Connect the DC plug of the power adaptor to

the rear panel connector, and loop cord

slack onto the cord hook so that the plug will

not be disconnected accidentally.

CAUTION

• Do not bend the cord tightly when you hang the

cord on the cord hook. Otherwise, a short-circuit or

fire may result.

WARNING

• An improper voltage setting can cause serious damage

to this instrument or result in improper operation.

■Connecting the pedal cord

Insert the pedal cord securely until the metal part of the

cord plug disappears from view. Otherwise, the pedal

may not function properly.

YDP-161/141 Owner's Manual

Keyboard Stand Assembly

Insert the cord all the

way until the metal part

of the plug disappears

from view.