Yamaha Arius YDP-162 소유자 매뉴얼 - 페이지 24

{카테고리_이름} Yamaha Arius YDP-162에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Arius YDP-162 36 페이지. Quick operation guide
Yamaha Arius YDP-162에 대해서도 마찬가지입니다: 참조 (8 페이지), 빠른 작동 매뉴얼 (2 페이지)

페이지 인쇄

Advanced Operations

Recording Your Performance

This instrument lets you record your keyboard performance as the User Song. Up to two Parts (left-hand and right-hand)

can be recorded separately.

Recording Your Performance

Select the desired Voice and other parameters, such as beat,

for recording.

For instructions on selecting a Voice, refer to page 16. If necessary, set other

parameters, such as beat and effects, in this step.

While holding down [REC], press [+R] or [–L] to engage

Record Ready mode for the Part you want to record.

If you do not intend to record right- and left-hand Parts separately, record the entire

performance to either Part.

Recording the right-hand Part ([+R])

Recording the left-hand Part ([–L])

After a while, the [REC] lamp and the selected Part lamp will flash at the current

tempo.

To exit from Record Ready mode:

Simply press [REC].

If data has already been recorded to the other Part:

The data in this Part will be played back while recording. This Part can be turned off

or on by holding down [PLAY] then pressing this Part button.

Play the keyboard or press [PLAY] to start recording.

The [REC] lamp lights up while the Recording Part lamp flashes at the current

tempo.

Press either [REC] or [PLAY] to stop recording.

The [REC], [PLAY], [+R] and [–L] lamps flash, indicating that the recorded data is

being stored. After the Save operation is completed, the lamps will turn off,

indicating that the Record operation has been completed.

YDP-162/142 Owner's Manual

Recording Capacity

This instrument can record up

to 100KB (approximately

11,000 notes).

NOTE

You can use the Metronome

while recording; however, the

Metronome sound will not be

recorded.

NOTICE

If a Part contains data, the

Part lamp lights. Note that the

Recording operation will

replace already-recorded data

with the new data.

NOTE

If the keyboard is in the Duo

mode (page 21), the data will

be recorded to each Part. The

Part for recording cannot be

specified.

NOTICE

Never turn off the power while

the recorded data is being

stored (while the lamps are

flashing). Otherwise, all

recorded data will be lost.