DirectBikes DB125T-13 매뉴얼 - 페이지 4

{카테고리_이름} DirectBikes DB125T-13에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DirectBikes DB125T-13 18 페이지.

(Illustration only)

Assembly

Front wheel

With the back of the motorcycle still being held

down it is now possible to insert the front wheel.

Firstly remove the plastic wedge from the brake

calliper. Offer the wheel up in-between the forks so

the brake disc sits correctly in the calliper. It is

vitally important that the brake pads sit on either

side of the disc.

Next insert the front wheel spindle through the fork

leg to which the calliper is attached, through the

spacer into the wheel and through the speedo drive

into the opposite fork leg. Put the nut onto the

spindle finger tight. Now check that the speedo

drive is correctly located, double check that the disc

is correctly located and tighten up. Pump the front

brake lever till it goes hard. Lastly put the chrome

covers on the lower fork, left and right.