Yamaha AvantGard N1 유지 관리 핸드북 - 페이지 41
{카테고리_이름} Yamaha AvantGard N1에 대한 유지 관리 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AvantGard N1 45 페이지. Hybrid piano
Yamaha AvantGard N1에 대해서도 마찬가지입니다: 소유자 매뉴얼 (50 페이지)
페이지 인쇄
N1 ARM LOWER ASSEMBLY REPLACEMENT PROCEDURE
* The following instructions describe the replacement of the arm lower assembly L.
Replacement of the arm lower assembly R is performed in the same way.
1)
Remove the top board unit.
2)
Remove the key cover unit.
3)
Remove the key block assembly L.
4)
Remove the front board assembly.
5)
Remove the arm upper assembly L.
<Top view>
[S32]
[S32]
ARM LOWER ASSEMBLY L
9)
Install the key block assembly L.
10) Adjust the damper holder height using damper holder
spacers.
Standard 1 Make sure the red felt does not rub against
keys and is not rolled up when opening the
key cover. (Fig. 2)
Standard 2 Make sure the gap between the red felt and
the keys is not too wide when the key cover
is opened. (Fig. 2)
(Reference) Standard value A (at shipment):
4.5 mm ± 1 mm, difference on the left and
right within 1 mm. (Fig. 2)
6)
Remove the connector assembly from the arm lower
assembly L.
7)
Measure the difference in level between the front of the
arm lower assembly L and the front rail.
8)
Remove the four (4) screws marked [S32], replace the
arm lower assembly L, and attach the connector assembly.
(Fig. 1)
At this time, make sure to attach with the difference in
level to the front rail measured in step 7).
Fig. 1
<Side view>
KEY COVER
KEY
A
FELT (RED)
[S32]
[S32]
ARM LOWER ASSEMBLY R
Fig. 2
N1
41