Yamaha AW4416 매뉴얼 보충 자료 - 페이지 23

{카테고리_이름} Yamaha AW4416에 대한 매뉴얼 보충 자료을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AW4416 48 페이지. Installing an internal hard disk
Yamaha AW4416에 대해서도 마찬가지입니다: 보충 설명서 (1 페이지), 튜토리얼 (34 페이지), 보충 설명서 (20 페이지), 매뉴얼 (3 페이지)

페이지 인쇄

Reference

This section explains all functions of the pages that were added in

AW4416 version 2.0.

QUICK REC screen

Visually patching input sources to tracks

Function

Individually patch 16 input sources to audio

tracks 1–16, and make settings for simulta-

neous recording in one operation.

Key operation

• [QUICK REC] key

[F2] (Quick Rec 2) key

• Repeatedly press the [QUICK REC] key until

the screen shown at the right appears.

Mouse operation

M button

QREC button

Screen functions

MIX.CH (Mixer channels)

This column shows the type of input sources

assigned to input channels 1–16. The

symbol displayed at the right of this area indicates

the direct output of each input channel.

When you move the cursor to the jack symbol and

press the [ENTER] key, the input channel for that

row will be selected for operations, and will be

highlighted. To cancel your selection, press the

[ENTER] key once again.

To change the input source assignment, move the

cursor to the numerical box for each input channel

and turn the [DATA/JOG] dial. The following input

sources can be assigned.

• AD 1–AD 8..... Input signals from the INPUT 1–

8 jacks

• SL1-1–SL1-8 ... Inputs 1–8 of an I/O card (slot 1)

• SL2-1–SL2-8 ... Inputs 1–8 of an I/O card (slot 2)

Quick Rec 2 page

Quick Rec 2 tab

(jack)

Version 2.0 Manual Supplement

• DIN L/DIN R....... L/R channels of the DIGITAL

STEREO IN jack

• SMP 1–SMP 8...... Sampling pads 1–8

• MET..................... Internal metronome

Patch cables

This area shows virtual patch cables that connect

the direct outputs of input channels 1–16 (MIX.CH

column) to recorder inputs 1–16 (REC.TR column).

To connect a patch cable, move the cursor to a

MIX.CH jack and press the [ENTER] key. Then

move the cursor to a REC.TR jack and press the

[ENTER] key. (You can make the same connection

by performing these steps in the opposite order.)

Use the CLEAR button (6) to defeat an individual

patch cable, or the ALL CLEAR button (5) to

defeat all patch cables.

6 7