Yamaha Clavinova CLP-840 소유자 매뉴얼 - 페이지 30

{카테고리_이름} Yamaha Clavinova CLP-840에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Clavinova CLP-840 40 페이지. Clavinova

페이지 인쇄

The Function Mode

IdJ

F3.5: 1 st Voice Effect Depth

(CLP·880/860/840) ....................................................................

F3.6: 2nd Voice Effect Depth

(CLP-880/860/840) ..................................................................

These functions make it possible to individually set the depth of the effect for the 1st and

2nd dual-mode Voices ("1st" and "2nd" is explained on page 16). Use the

[-/NO]

and

[+1

YES] buttons to set the effect depth for the corresponding voice as required. The depth range

is from 0 through 20. A setting of "0" produces no effect, while a setting of "20" produces

maximum effect depth. Press the

[-/NO]

and [+/YES] buttons simultaneously to recall the

default setting (different for each voice combination).

L!l

NOTE

I .

The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be

exited before EFFECT can be turned ON.

IdJ

F3.5: Reset

(CLP-820/820S) .......................................................................................................................

F3.7: Reset

(CLP-880/860/840) .................................................................................................................

This function resets all dual-mode functions to their default values. Press the [+/YES]

button to reset the values.

"E tid"

will appear on the display when all functions have been

reset.

III

CLP-880/860 Split Mode Functions - - - - - -

After selecting "F'-1.:l", press the [+/YES] button to engage the split-mode function sub

mode, then use the FUNCTION [....] and

[~]

buttons to select the desired split mode func

tion, as listed below.

If the Split mode is not engaged "F

Y. - "

will appear instead of

Y8"

and the Split mode

functions cannot be selected. Also note that you must exit from the Function mode before the

Split mode can be engaged .

• SHORTCUT: You can jump directly to the split-mode functions (F4) by pressing the

[FUNCTION] button while holding the [SPLIT] button.

L!l

NOTE

I .

Split mode function settings are set individually for each voice combination.

F4.1: Split Point ............................................................................................................................................

In addition to the split point setting method described on page 17, the split point can be set

via this function. Use the [-IN

and [+/YES] buttons to set the split point as required, or

simply press the appropriate key on the keyboard: from "A-I" to "C7". Press the

[-/NO]

and

[+/YES] buttons simultaneously to recall the default setting "Fi2".

F4.2: Split

Balance .....................................................................................................................................

The volume levels of the two voices combined in the split mode can be adjusted as re

quired by using this function. Use the

[-/NO]

and [+/YES] buttons to adjust the balance as

required. The balance range is from 0 through 20. A setting of "10" produces equal balance

between the two split-mode voices. Settings below "10" increase the volume of the Left Voice

in relation to the Right Voice, and settings above "10" increase the volume of the Right Voice