Yamaha DM 2000 Version 2 보충 설명서

{카테고리_이름} Yamaha DM 2000 Version 2에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DM 2000 Version 2 4 페이지. Version 2
Yamaha DM 2000 Version 2에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (22 페이지), 소프트웨어 설치 매뉴얼 (13 페이지), 소유자 매뉴얼 (1 페이지), 소유자 매뉴얼 (37 페이지), 설정 매뉴얼 (35 페이지), 오리엔테이션 매뉴얼 (8 페이지), 이중화 매뉴얼 (8 페이지), 소유자 매뉴얼 (3 페이지), (독일어) 운영 체제 설치 매뉴얼 (13 페이지)

페이지 인쇄

Yamaha DM2000 Update V1.1

This document explains the new and revised func-

tions for DM2000 Update 1.1.

Scene Memory & Input/Output Patch

Linking

Input Patch and Output Patch library memories can

be linked to Scene memories so that when a Scene is

recalled, the input and output patches are recalled as

well.

The PATCH LINK INPUT and OUTPUT parame-

ters can be found on the Scene Memory page shown

below, which is located by pressing the SCENE

MEMORY [DISPLAY] button.

Use the cursor buttons to select the PATCH LINK

INPUT and OUTPUT parameters, use the Parame-

ter wheel to select Input Patch and Output Patch

library memories, and press the [ENTER] button to

set. A dash (–) means that no patch memory is

selected.

When you store a Scene, the last recalled or stored

Input Patch and Output Patch library memories are

automatically linked to that Scene.

If the speciﬁed Input or Output Patch library mem-

ory contains no data, only the Scene is recalled, the

input and output patching will remain the same.

Bass Management for 3-1 & ST

Monitor Matrixes

Bass Management can now be used with the 3-1 and

Stereo Out monitor matrixes. Previously, Bass Man-

agement could be used only with the 5.1 monitor

matrix. The Bass Management function can be

found on the Surround Monitor Setup page, which

can be located by using the MONITOR [DISPLAY]

button when either the 3-1 or 5.1 Surround mode is

selected.

The following screen shots show the Bass Manage-

ment conﬁgurations for the 5.1, 3-1, and Stereo

monitor matrixes, with Bass Management turned on

and off.

5.1 ON

3-1 ON

ST ON

Note: When using the 3-1 monitor matrix, even with

ﬁlm sources, use Bass Management presets 1 and 2

(presets 3 and 4 may not provide correct monitoring).

In addition, the Monitor Matrix conﬁgurations have

changed as follows. (The 5.1 to 5.1 matrix is

unchanged.)

3-1 to 3-1

3-1 to ST

5.1 to ST

5.1 OFF

3-1 OFF

ST OFF

5.1 to 5.1

5.1 to 3-1