Yamaha DTX500K 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Yamaha DTX500K에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DTX500K 48 페이지. Drum trigger module

When a pad-controller-equipped pad (XP100SD, etc.) is connected, you can adjust the snares setting and tightness, tuning, or

tempo by rotating the pad controller knob of the pad.

Operation

In the default setting, you can adjust the snares setting

and tightness using the pad controller of the XP100SD

(the snare drum pad). To use functions other than the

snares adjustment, change the setting as follows.

1. Press the [DRUM KIT] button to enter the Drum Kit

Select display.

KIT1~~~_________

1~:Oak~Custom~~‚

2. Next, continue pressing the [>] button until Page 22

of the Drum Kit Select pages is called up.

3. Rotate the jog dial to change the value for

"PadCtl=". You can select from the following func-

tions.

off .......... No function is assigned.

snares .... Adjusting the snares setting and tight-

ness (also affects the open rim sound)

tuning.... Tuning adjustment (also affects the open

rim sound)

tempo ...... Adjusting the tempo

KIT22*

"PadCtl=tuning~‚

NOTICE

• An asterisk "

" will appear next to "

display if the data has been changed. This asterisk

will disappear after the Store operation (p. 32) is car-

ried out. If a different drum kit is selected or the

power is turned off before carrying out the Store

operation, the current settings will return to their

original condition. If you want to keep changes made

to the data, make sure to carry out the Store opera-

tion.

Pad Controller Settings

KIT22

" in the

Operation (Replacing the pad with one equipped

with pad controller)

Here's how you can use the pad with pad controller

(XP100SD) as a snare drum.

1. Connect the XP100SD with trigger input 1SNARE

on the DTX500.

* The other trigger input jacks other than the 1SNARE are

not compatible with pad-controller-equipped pads. The

pad controller will not work if this type of pad is connected

to a trigger input jack other than 1SNARE.

2. Press the [SHIFT] + [DRUM KIT] buttons to view the

Trigger Setup display.

TRG1~~~ååååååååå

1~:XP Med~~~~~~‚

3. Next, press the [>] button once to view the following

display (pad type).

Hit the snare pad to view "ƒsnare" in the upper half

of the display, then rotate the jog dial to set

"Type=SN-1."

TRG2*~ƒsnare~~0%

"Type=SN-1~~~~~‚

NOTICE

• An asterisk "

" will appear next to "

play if the data has been changed. This asterisk will

disappear after the Store operation (p. 34) is carried

out. If a different drum kit is selected or the power is

turned off before carrying out the Store operation, the

current settings will return to their original condition.

If you want to use the selected pad again, make sure

to carry out the Store operation.

4. Now you are ready to use the pad-controller-

equipped pad.

See the section "Operation" in the left column to

change the function you want to use for the pad con-

troller.

DTX500 Owner's Manual

2 Time to Play

TRG2

" in the dis-