Yamaha RBX170EW 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Yamaha RBX170EW에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha RBX170EW 11 페이지. Electric bass

When the string gauge and/or bridge height is changed, or the

truss rod is adjusted, it is usually necessary to reintonate the

bridge saddles. If the bass plays out of tune in the higher reg-

isters, this adjustment is needed. Check each string in the fol-

lowing way:

To check intonation, compare the harmonic tone (12th fret) to

the fretted tone (12th fret). Because the 12th fret is the midway

point between the nut and the bridge, a harmonic tone one

octave higher than the fretted tone can be generated. This is

done by barely touching the string directly above the 12th fret

(left hand) and simultaneously plucking the same string (right

hand). If the fretted tone is exactly the same pitch as the har-

monic tone, no adjustments to the bridge saddles are neces-

sary. However, if the fretted tone is higher in pitch (sharp) or

lower in pitch (flat) than the harmonic tone, apply the appropri-

ate adjustment as shown below. Repeat the same procedure

for each string.

INTONATION ADJUSTMENT

If the fretted note is pitched higher than the harmonic, turn the

corresponding saddle adjustment screw clockwise, increasing

the active string length.

Conversely, if the fretted note is pitched lower than the har-

monic, turn the corresponding saddle adjustment screw coun-

ter-clockwise, reducing the active string length.

When lower

than harmonic

When higher

than harmonic