Yamaha Silent Piano SC2 소유자 매뉴얼 - 페이지 22

{카테고리_이름} Yamaha Silent Piano SC2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Silent Piano SC2 47 페이지.

Chapter

Recording and Playback

This instrument allows you to record your performance by using one of the following two methods. The

recorded performance can be played back and saved for use with other devices.

MIDI recording

With this method, your keyboard performances are recorded and saved to internal memory of this unit as a

MIDI Song (SMF format 0). In a MIDI song, the information of your keyboard performance (such as keystroke

and velocity) is recorded. This is not a recording of the actual sound. Information such as the selected Voice,

Beat and Tempo is also recorded to the MIDI Song. The recorded MIDI Song can be transmitted and saved to

a computer (page 31).

Audio recording

With this method, your keyboard performances are recorded then saved to USB flash drive as an Audio Song

in stereo WAV format of normal CD-quality resolution (44.1 kHz/16 bit, stereo). The saved Audio Song can be

transmitted to and played on portable music players.

NOTE

You can use the metronome (page 19) while recording, although the metronome sound will not be recorded.

Recording your performance to internal memory (MIDI

recording)

One Song can be recorded in the MIDI format to the internal memory of this unit. The recorded MIDI Song is

maintained in the internal memory even when the power is turned off.

NOTICE

Note that recording to internal memory will overwrite any previously recorded data. To prevent your important data

from being overwritten and erased, save the necessary data to a computer (page 31).

NOTE

• This instrument can record up to approximately 500 KB (approx. 55,000 notes). This is equivalent to about 40 minutes for

conventional songs. However, frequent use of the pedals or changing of Voices while playing may cause the recording time

to be shortened to five minutes.

• You cannot start recording during Song playback. Make sure to stop playback beforehand.

Disconnect the USB flash drive from this unit, if it is connected.

You cannot record to the internal memory when a USB flash drive is connected to the unit.

Press the [Rec] button to put recording in

standby.

The [Rec] lamp lights in red, and the [R/J] (Play/Stop)

lamp flashes in orange.

NOTE

To cancel recording standby status, press the [Rec] button again.

If you cancel recording and exit from recording standby status,

the previously recorded data will be maintained.

SC2 Owner's Manual

Lights up

Flashes