Yamaha Sonogenic SHS-500 참조 매뉴얼 - 페이지 12

{카테고리_이름} Yamaha Sonogenic SHS-500에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Sonogenic SHS-500 28 페이지.
Yamaha Sonogenic SHS-500에 대해서도 마찬가지입니다: 소유자 매뉴얼 (45 페이지)

페이지 인쇄

How to Use the Terminals

Audio Loop Back

You can set whether Audio sound input from the [TO HOST] terminal is returned to the smart device

or the computer or not with the performance played on the instrument by setting the Function

"Audio Loop Back"

(page

played on this instrument to the smart device or the computer, set this parameter to off.

NOTICE

If you are using a DAW (digital audio workstation) with this instrument, set Audio Loop Back

to OFF. Otherwise, a loud sound may occur, depending on the settings of the computer or the application

software.

Precautions when using the [TO HOST] terminal

When connecting the computer to the [TO HOST] terminal, make sure to observe the following

points to avoid freezing the computer and corrupting or losing the data.

NOTICE

• Use an AB type USB cable of less than 3 meters. USB 3.0 cables cannot be used.

• Execute the following before turning the power to the instrument on/off or plugging/

unplugging the USB cable to/from the [TO HOST] terminal.

• Quit any open application software on the computer.

• Make sure that data is not being transmitted from the instrument. (Data is transmitted only

by playing notes on the keyboard or playing back a song.)

• While the computer is connected to the instrument, you should wait for six seconds or more

between these operations: (1) when turning the power of the instrument off then on again,

or (2) when alternately connecting/disconnecting the USB cable.

If the computer or the instrument freezes, restart the application software or the computer OS,

or turn the power to the instrument off then on again.

5). The default setting is on. If you want to output only the sound

TO HOST

SHS-500

Audio data

Return with the keyboard

performance

Smart

device

(page