Yamaha SYSTEM-55T 소유자 매뉴얼

{카테고리_이름} Yamaha SYSTEM-55T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha SYSTEM-55T 1 페이지. Electric acoustic guitar

페이지 인쇄

ELECTRIC

ACOUSTIC GUITAR

Owner's Manual

Thank you for choosing a Yamaha electric-acoustic guitar.

In order to make the most of the advanced features and

performance provided by your guitar, please read this

manual carefully before using the instrument.

PRECAUTIONS

The output jack is an EIAJ-standard 1/4" phone jack. Be sure to use

an appropriate connection cable.

The built-in preamplifier is automatically turned on when a plug is

inserted into the output jack. When not using the instrument, or when

playing it without amplification, be sure to remove the plug from the

output jack so that the preamplifier power is turned off.

Always set the VOLUME control to "0" when plugging in or

unplugging the connection cable.

The battery check indicator (BATT.) will light briefly when a plug is

inserted or removed from the output jack. This is normal and does not

indicate a malfunction.

Be sure to remove the battery if the instrument will not be used for an

extended period of time in order to prevent possible damage due to

battery leakage.

NOMENCLATURE

Control Section

Output Jack (with power switch function)

BATTERY REPLACEMENT

Be sure to replace the battery as soon as possible when the battery check

indicator lights in order to avoid reduced sound quality.

* Be sure to remove the battery if the instrument will not be used for an extended

period of time in order to prevent possible damage due to battery leakage.

q Press the catch on the battery holder in the direction indicated by the arrow

in the illustration in order to unlock it.

w Slide out the battery case.

e Remove the old battery from the battery case, and insert the new battery

making sure that the (+) and (–) terminals of the battery are positioned as

shown in the illustration. Use only a DC9V, S-006P (6F22) or equivalent

battery.

r Slide the battery case back into the battery holder and press firmly so

that the battery case locks into place.

w, r

Catch

Battery Holder

Bar Sensor

DC9V S-006P

Battery case

(6F22)

SPECIFICATIONS

System

SYSTEM-55T: Monaural 1 way

Pickup

Bar Sensor (Piezo type)

Pre-amplifier Controls

VOL., 3 Band (HIGH, MID, LOW) EQ

control, AMF control

Output jack

Combination end pin/power switch

Output impedance

1 kΩ

Power supply

9V DC, S-006P (6F22) dry cell battery

Battery life

Approx. 150 hours (without tuner)

Approx. 140 hours (with the preamp

switched ON and the tuner used 1 minute

every 1 hour)

Tuner

Tuning System: Chromatic type (12

semitones), A4=440Hz

Auto OFF Function: Tuner automatically

switches OFF after 2 minutes.

Input: Built in pickup (bridge bar sensor)

Accuracy: +/– 3 cents

Accessories

• Hexagonal wrench for neck adjustment x1

• S-006P (6F22) dry cell battery x1

THE CONTROLS

q VOL. (Volume) Control

Adjusts the overall output volume level.

* Make sure that the VOL. is turned to "0"

before connecting or disconnecting.

w BATT. (Battery Check) Indicator

This indicator will light when the battery

needs to be replaced.

Please replace the battery as soon as

possible when the BATT. indicator lights.

e 3 Band Equalizer

LOW : Boosts or cuts the level of the low frequencies.

MID : Boosts or cuts the level of the middle frequencies.

The AMF control r adjusts the center frequency of the band

affected by this control.

HIGH : Boosts or cuts the level of the high frequencies.

r AMF Control

Sets the center frequency of the band of frequencies affected by the MID

equalizer control. The range is from 80 Hz to 10 kHz.

* This control has no effect when the MID equalizer control is set to its center

("0") position.

Tuner Switch

Switches the tuner ON/OFF.

Tuner Display

Displays tuner information.

USING THE TUNER

The guitar is equipped with an A4=440Hz standard pitch tuner. The

tuner's circuitry is independent from the guitar's output circuit so

switching the tuner ON/OFF will have no affect on sound output.

Press the TUNER switch. While the tuner activates the

light alternately.

Tune the guitar string until the note name of the desired pitch appears in

the tuner's display.

The

lamp indicates the pitch is low.

The

lamp indicates the pitch is high.

The pitch indicator (

note shown in the display.

The string is in tune when the

* The tuner will automatically switch OFF approximately two minutes after the

TUNER switch is pressed (energy saving function). To continue tuning, press

the TUNER switch again.

* It may take a few seconds before the tuner can detect pitches after being switched

ON.

* The note name and

displays may have difficulty keeping up with irregular

pitch changes. Gradually change the pitch and check when tuning.

* The tuner may have difficulty detecting notes rich with overtones or with very

short sustain.

) flashes slower as the string's pitch nears the

and

lamps both light.

and

lamps